| /linux-6.14.4/Documentation/devicetree/bindings/misc/ |
| D | qemu,vcpu-stall-detector.yaml | 4 $id: http://devicetree.org/schemas/misc/qemu,vcpu-stall-detector.yaml#
7 title: VCPU stall detector
10 This binding describes a CPU stall detector mechanism for virtual CPUs
19 - qemu,vcpu-stall-detector
27 The internal clock of the stall detector peripheral measure in Hz used
37 The stall detector expiration timeout measured in seconds.
52 compatible = "qemu,vcpu-stall-detector";
|
| /linux-6.14.4/drivers/extcon/ |
| D | Kconfig | 39 FSA9480 microUSB switch and accessory detector chip. The FSA9480 is a USB
40 port accessory detector and switch. The FSA9480 is fully controlled using
84 microUSB switch and accessory detector chip. The LC824206XA is a USB
85 port accessory detector and switch. The LC824206XA is fully controlled
97 detector and switch.
116 detector and switch.
126 detector add switch.
135 detector and switch.
168 Richtek RT8973A. The RT8973A is a USB port accessory detector
181 detector and switch.
|
| /linux-6.14.4/Documentation/trace/ |
| D | hwlat_detector.rst | 2 Hardware Latency Detector
24 The hardware latency detector works by hogging one of the cpus for configurable
31 Note that the hwlat detector should *NEVER* be used in a production environment.
55 for every 1,000,000 usecs (1s) the hwlat detector will spin for 500,000 usecs
64 If tracing_thresh was zero when hwlat detector was started, it will be set
66 tracing_thresh that hwlat detector had will be saved and this value will
67 be restored in tracing_thresh if it is still zero when hwlat detector is
81 By default, one hwlat detector's kernel thread will migrate across each CPU
|
| /linux-6.14.4/drivers/misc/ |
| D | vcpu_stall_detector.c | 3 // VCPU stall detector.
63 /* Reload the stall detector counter register every in vcpu_stall_detect_timer_fn()
83 panic("vCPU stall detector"); in vcpu_stall_detector_irq()
97 /* Compute the number of ticks required for the stall detector in start_stall_detector_cpu()
105 /* Enable the internal clock and start the stall detector */ in start_stall_detector_cpu()
108 /* Pet the stall detector at half of its expiration timeout in start_stall_detector_cpu()
132 /* Disable the stall detector for the current CPU */ in stop_stall_detector_cpu()
228 { .compatible = "qemu,vcpu-stall-detector", },
247 MODULE_DESCRIPTION("VCPU stall detector");
|
| /linux-6.14.4/Documentation/devicetree/bindings/media/xilinx/ |
| D | xlnx,v-tc.txt | 5 detector.
18 - xlnx,detector: The VTC has a timing detector
21 At least one of the xlnx,detector and xlnx,generator properties must be
|
| /linux-6.14.4/Documentation/devicetree/bindings/iio/adc/ |
| D | envelope-detector.yaml | 4 $id: http://devicetree.org/schemas/iio/adc/envelope-detector.yaml#
7 title: ADC envelope detector using a DAC and a comparator
32 const: axentia,tse850-envelope-detector
77 envelope-detector {
78 compatible = "axentia,tse850-envelope-detector";
|
| D | holt,hi8435.yaml | 7 title: Holt Integrated Circuits HI-8435 SPI threshold detector
44 threshold-detector@0 {
|
| /linux-6.14.4/drivers/net/wireless/ath/ |
| D | dfs_pattern_detector.h | 59 * struct radar_detector_specs - detector specs for a radar pattern type
85 * struct dfs_pattern_detector - DFS pattern detector
87 * @set_dfs_domain(): set DFS domain, resets detector lines upon domain changes
88 * @add_pulse(): add radar pulse to detector, returns true on detection
115 * dfs_pattern_detector_init() - constructor for pattern detector class
|
| D | dfs_pattern_detector.c | 152 * struct channel_detector - detector elements for a DFS channel
154 * @freq: frequency for this channel detector in MHz
155 * @detectors: array of dynamically created detector elements for this freq
158 * to support off-channel scanning. A pattern detector has a list of channels
167 /* channel_detector_reset() - reset detector lines for a given channel */
227 * channel_detector_get() - get channel detector for given frequency
231 * Return value: pointer to channel detector on success, NULL otherwise
233 * Return existing channel detector for the given frequency or return a
248 * DFS Pattern Detector
285 /* reset detector on time stamp wraparound, caused by TSF reset */ in dpd_add_pulse()
|
| D | dfs_pri_detector.h | 47 * struct pri_detector - PRI detector element for a dedicated radar type
51 * @rs: detector specs for this detector element
|
| /linux-6.14.4/Documentation/admin-guide/ |
| D | lockup-watchdogs.rst | 2 Softlockup detector and hardlockup detector (aka nmi_watchdog)
46 'hardlockup detector' (the handler for the NMI perf event) will
53 'softlockup detector' (coded inside the hrtimer callback function)
60 detector kicks in.
|
| /linux-6.14.4/Documentation/devicetree/bindings/iio/frequency/ |
| D | adi,admv1013.yaml | 64 Envelope Detector voltage regulator.
82 adi,detector-enable:
84 Enable the Envelope Detector available at output pins VENV_P and
151 adi,detector-enable;
|
| D | adi,admv1014.yaml | 81 adi,detector-enable:
83 Digital Rx Detector Enable. The Square Law Detector output is
141 adi,detector-enable;
|
| D | adi,adf4350.yaml | 65 adi,phase-detector-polarity-positive-enable:
67 description: Enables positive phase detector polarity. Default negative.
193 adi,phase-detector-polarity-positive-enable;
|
| /linux-6.14.4/include/linux/ |
| D | nmi.h | 68 * 'watchdog_enabled' variable. Each lockup detector has its dedicated bit -
69 * bit 0 for the hard lockup detector and bit 1 for the soft lockup detector.
140 * Pass on to the hardlockup detector selected via CONFIG_. Note that in touch_nmi_watchdog()
141 * the hardlockup detector may not be arch-specific nor using NMIs in touch_nmi_watchdog()
|
| /linux-6.14.4/kernel/ |
| D | watchdog.c | 8 * detector, so thanks to Ingo for the initial implementation.
231 * These functions can be overridden based on the configured hardlockdup detector.
234 * softlockup watchdog start and stop. The detector must select the
242 * Watchdog-detector specific API.
561 * hardlockup detector generates a warning in set_sample_period()
660 /* watchdog detector functions */
695 /* kick the softlockup detector */ in watchdog_timer_fn()
805 /* Enable the hardlockup detector */ in watchdog_enable()
817 * Disable the hardlockup detector first. That prevents that a large in watchdog_disable()
819 * detector causes a false positive. in watchdog_disable()
[all …]
|
| /linux-6.14.4/Documentation/RCU/ |
| D | stallwarn.rst | 4 Using RCU's CPU Stall Detector
8 detector can locate, and then discusses kernel parameters and Kconfig
9 options that can be used to fine-tune the detector's operation. Finally,
10 this document explains the stall detector's "splat" format.
136 Fine-Tuning the RCU CPU Stall Detector
140 CPU stall detector, which detects conditions that unduly delay RCU grace
143 The stall detector's idea of what constitutes "unduly delayed" is
198 The CPU stall detector tries to make the offending CPU print its
225 Interpreting RCU's CPU Stall-Detector "Splats"
|
| /linux-6.14.4/drivers/net/wireless/ath/ath9k/ |
| D | dfs_debug.c | 55 "DFS detector not enabled\n"); in read_file_dfs()
61 len += scnprintf(buf + len, size - len, "Pulse detector statistics:\n"); in read_file_dfs()
71 len += scnprintf(buf + len, size - len, "Radar detector statistics " in read_file_dfs()
|
| /linux-6.14.4/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-adc-hi8435 | 6 Program sensor type for threshold detector inputs.
8 threshold detector input channel. Channels 0..7, 8..15, 16..23
|
| /linux-6.14.4/drivers/iio/adc/ |
| D | envelope-detector.c | 3 * Driver for an envelope detector using a DAC and a comparator
359 0, "envelope-detector", env); in envelope_detector_probe()
392 { .compatible = "axentia,tse850-envelope-detector", },
400 .name = "iio-envelope-detector",
406 MODULE_DESCRIPTION("Envelope detector using a DAC and a comparator");
|
| /linux-6.14.4/lib/ |
| D | Kconfig.kmsan | 12 bool "KMSAN: detector of uninitialized values use"
19 KernelMemorySanitizer (KMSAN) is a dynamic detector of uses of
|
| D | Kconfig.kfence | 7 bool "KFENCE: low-overhead sampling-based memory safety error detector"
12 KFENCE is a low-overhead sampling-based detector of heap out-of-bounds
|
| /linux-6.14.4/kernel/trace/ |
| D | trace_hwlat.c | 3 * trace_hwlat.c - A simple Hardware Latency detector.
389 * stop_stop_kthread - Inform the hardware latency sampling/detector kthread to stop
391 * This kicks the running hardware latency sampling/detector kernel thread and
414 * start_single_kthread - Kick off the hardware latency sampling/detector kthread
471 * stop_per_cpu_kthreads - Inform the hardware latency sampling/detector kthread to stop
473 * This kicks the running hardware latency sampling/detector kernel threads and
573 * start_per_cpu_kthreads - Kick off the hardware latency sampling/detector kthreads
673 * to the hardware latency detector. hwlatd has different operation modes.
|
| /linux-6.14.4/Documentation/devicetree/bindings/sound/ |
| D | fsl,micfil.yaml | 37 - description: voice activity detector event interrupt
38 - description: voice activity detector error interrupt
|
| /linux-6.14.4/drivers/net/wireless/mediatek/mt76/ |
| D | mt76x02_dfs.c | 211 /* reset hw detector */ in mt76x02_dfs_detector_reset()
214 /* reset sw detector */ in mt76x02_dfs_detector_reset()
632 /* sw detector rx radar pattern */ in mt76x02_dfs_tasklet()
659 /* hw detector rx radar pattern */ in mt76x02_dfs_tasklet()
667 /* reset hw detector */ in mt76x02_dfs_tasklet()
816 /* disable hw detector */ in mt76x02_phy_dfs_adjust_agc()
818 /* enable hw detector */ in mt76x02_phy_dfs_adjust_agc()
836 /* disable hw detector */ in mt76x02_dfs_init_params()
838 /* clear detector status */ in mt76x02_dfs_init_params()
|