Searched full:cmd19 (Results 1 – 10 of 10) sorted by relevance
135 Specify the start delay cell point when send first CMD19 in tuning procedure.
628 * When tuning CMD19 is issued twice for each tap, merge the in renesas_sdhi_select_tuning()702 /* Issue CMD19 twice for each tap */ in renesas_sdhi_execute_tuning()
658 unsigned int tuning_done; /* Condition flag set when CMD19 succeeds */
74 {3, 1}, /* CMD19 */
1723 /* CMD19 is special in that the Data Present Select should be set */ in sdhci_send_command()2832 * In response to CMD19, the card sends 64 bytes of tuning in sdhci_send_tuning()3409 * CMD19 generates _only_ Buffer Read Ready interrupt if in sdhci_data_irq()
503 struct msdc_tune_para saved_tune_para; /* tune result of CMD21/CMD19 */1357 * may have already come when cmd19/cmd21 gets response in msdc_cmd_done()
660 * SPI mode doesn't define CMD19 and tuning is only valid for SDR50 and in mmc_sd_init_uhs_card()671 * Version 3.01 says, CMD19 tuning is available for unlocked in mmc_sd_init_uhs_card()673 * difference between v3.00 and 3.01 spec means that CMD19 in mmc_sd_init_uhs_card()
712 * is normally shorter 40 executions of CMD19, in mmc_send_tuning()
614 * SPI mode doesn't define CMD19 and tuning is only valid for SDR50 and in mmc_sdio_init_uhs_card()
405 #define MMC_CAP_BUS_WIDTH_TEST (1 << 15) /* CMD14/CMD19 bus width ok */