Searched full:uniquely (Results 1 – 25 of 196) sorted by relevance
12345678
99 The first part must uniquely name the MAC controller. Then follows the110 The first part must uniquely name the PHY. This often means uniquely
32 uniquely determined by the enumeration address containing 4 fields::52 - Device index, which uniquely identifies multiple devices within a
55 * Reference field uniquely identifies port that published name sequence.56 * Key field uniquely identifies publication, in the event a port has
16 * @consumer_dev_name: Name to uniquely identify the consumer device.
22 Specifies the BD address that was uniquely assigned to the Bluetooth
14 numbered uniquely in a device dependent manner. The nodes for an MDIO
70 PID stands for Provisioned ID and is used to uniquely identify141 PID stands for Provisioned ID and is used to uniquely identify
25 * service, so the generated TDREPORT can be uniquely verified.
75 /* DrSW: Uniquely identifies the software interface to a board. This105 /* DrHW: Uniquely identifies the hardware interface to a board (or at
46 * These token values are used to uniquely identify specific LSMs
28 * types are uniquely identified by the PCIe compatible SBDF number.
18 - ibm,port-name: Firmware provides this name that uniquely identifies the i2c
14 uniquely in a device dependent manner. The nodes for an i2c bus
48 Number of cells required to uniquely identify the thermal
34 Used to uniquely identify a thermal sensor instance within an IC. Will be
18 i.e. some way to uniquely and unambiguously define a color so that85 To recapitulate: the CIE XYZ colorspace uniquely identifies colors.
25 * ctx_id uniquely identifies this mm_struct. A ctx_id will never
65 __u32 magic; /* To uniquely identify a core file */
309 /* Nothing uniquely required for an configuration */ in xgbe_phy_an_config()643 /* Nothing uniquely required for stop */ in xgbe_phy_stop()648 /* Nothing uniquely required for start */ in xgbe_phy_start()675 /* Nothing uniquely required for exit */ in xgbe_phy_exit()
53 u32 magic; /* To uniquely identify a core file */
10 # Every controller needs to be uniquely identified on the platform. To achieve
28 string to uniquely identify variant of the calibration data for designs
36 A subtype index is added at the end of this IOCTL CMD to uniquely identify the
74 The FID record can be used to uniquely identify the inode that triggered
72 * Each shaper is uniquely identified within the device with a 'handle'