Home
last modified time | relevance | path

Searched +full:trickle +full:- +full:charge +full:- +full:current +full:- +full:microamp (Results 1 – 8 of 8) sorted by relevance

/linux-6.14.4/Documentation/devicetree/bindings/power/supply/
Drohm,bd99954.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Matti Vaittinen <[email protected]>
11 - Markus Laine <[email protected]>
12 - Mikko Mutanen <[email protected]>
15 The ROHM BD99954 is a Battery Management LSI for 1-4 cell Lithium-Ion
16 secondary battery intended to be used in space-constraint equipment such
18 provides a Dual-source Battery Charger, two port BC1.2 detection and a
21 $ref: power-supply.yaml#
[all …]
Dbattery.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Sebastian Reichel <[email protected]>
14 In smart batteries, these are typically stored in non-volatile memory
16 no appropriate non-volatile memory, or it is unprogrammed/incorrect.
27 Batteries must be referenced by chargers and/or fuel-gauges using a phandle.
28 The phandle's property should be named "monitored-battery".
32 const: simple-battery
34 device-chemistry:
[all …]
/linux-6.14.4/drivers/power/supply/
Dbd99954-charger.c1 // SPDX-License-Identifier: GPL-2.0-only
16 * Curve (1) represents charging current.
20 * a) Trickle-charge with constant current (8).
21 * b) pre-charge with constant current (6)
22 * c) fast-charge, first with constant current (5) phase. After
24 * voltage phase until charging current has dropped to termination
30 *(4)` `.` ` ` ` ` ` ` ` ` ` ` ` ` ` ----------------------------.
32 * . o----+/:/ ` ` ` ` ` ` ` ` ` ` ` ` `.` ` (5)
34 * . + /- -- .
35 * . +`/- + .
[all …]
Dcpcap-charger.c1 // SPDX-License-Identifier: GPL-2.0-only
10 * Copyright (C) 2009-2010 Motorola, Inc.
31 #include <linux/mfd/motorola-cpcap.h>
38 * similar. Also see the Motorola Linux kernel cpcap-regbits.h. CPCAP_REG_CHRGR_1
45 #define CPCAP_REG_CRM_ICHRG_TR1 BIT(11) /* Trickle charge current */
49 #define CPCAP_REG_CRM_VCHRG3 BIT(7) /* Charge voltage bits */
53 #define CPCAP_REG_CRM_ICHRG3 BIT(3) /* Charge current bits */
58 /* CPCAP_REG_CRM trickle charge voltages */
66 * CPCAP_REG_CRM charge voltages based on the ADC channel 1 values.
89 * CPCAP_REG_CRM charge currents. These seem to match MC13783UG.pdf
[all …]
Dmax77693_charger.c1 // SPDX-License-Identifier: GPL-2.0+
3 // max77693_charger.c - Battery charger driver for the Maxim 77693
13 #include <linux/mfd/max77693-common.h>
14 #include <linux/mfd/max77693-private.h>
16 #define MAX77693_CHARGER_NAME "max77693-charger"
49 /* In high temp the charging current is reduced, but still charging */ in max77693_get_charger_state()
88 * Top-off: trickle or fast? In top-off the current varies between in max77693_get_charge_type()
89 * 100 and 250 mA. It is higher than prequalification current. in max77693_get_charge_type()
96 /* In high temp the charging current is reduced, but still charging */ in max77693_get_charge_type()
118 * - POWER_SUPPLY_HEALTH_DEAD
[all …]
Dsmb347-charger.c1 // SPDX-License-Identifier: GPL-2.0-only
23 #include <dt-bindings/power/summit,smb347-charger.h>
26 #define SMB3XX_SOFT_TEMP_COMPENSATE_DEFAULT -1
29 #define SMB3XX_TEMP_USE_DEFAULT -273
34 * reloaded from non-volatile registers after POR.
136 * struct smb347_charger - smb347 charger instance
147 * @max_charge_current: maximum current (in uA) the battery can be charged
149 * @pre_charge_current: current (in uA) to use in pre-charging phase
150 * @termination_current: current (in uA) used to determine when the
153 * pre-charge to fast charge mode
[all …]
Dpower_supply_core.c1 // SPDX-License-Identifier: GPL-2.0-only
25 #include <linux/fixp-arith.h>
27 #include "samsung-sdi-battery.h"
48 if (!supply->supplied_from && !supplier->supplied_to) in __power_supply_is_supplied_by()
52 if (supply->supplied_from) { in __power_supply_is_supplied_by()
53 if (!supplier->desc->name) in __power_supply_is_supplied_by()
55 for (i = 0; i < supply->num_supplies; i++) in __power_supply_is_supplied_by()
56 if (!strcmp(supplier->desc->name, supply->supplied_from[i])) in __power_supply_is_supplied_by()
59 if (!supply->desc->name) in __power_supply_is_supplied_by()
61 for (i = 0; i < supplier->num_supplicants; i++) in __power_supply_is_supplied_by()
[all …]
Dbq24190_charger.c1 // SPDX-License-Identifier: GPL-2.0-only
19 #include <linux/extcon-provider.h>
32 #define BQ24190_REG_POC 0x01 /* Power-On Configuration */
56 #define BQ24190_REG_CCC 0x02 /* Charge Current Control */
63 #define BQ24190_REG_PCTCC 0x03 /* Pre-charge/Termination Current Cntl */
75 #define BQ24190_REG_CVC 0x04 /* Charge Voltage Control */
84 #define BQ24190_REG_CTTC 0x05 /* Charge Term/Timer Control */
162 * The tables below provide a 2-way mapping for the value that goes in
163 * the register field and the real-world value that it represents.
165 * number at that index in the array is the real-world value that it
[all …]