Searched full:blinks (Results 1 – 21 of 21) sorted by relevance
| /linux-6.14.4/drivers/leds/ |
| D | leds-ipaq-micro.c | 28 * yellow LED is always ~30 blinks per minute in micro_leds_brightness_set()
65 * yellow LED is always ~30 blinks per minute in micro_leds_blink_set()
|
| D | leds-tca6507.c | 49 * Access to the 3 levels and 2 blinks are on a first-come,
|
| D | Kconfig | 539 cannot change its brightness it blinks instead. The brightness
|
| /linux-6.14.4/Documentation/ABI/testing/ |
| D | sysfs-block-device | 13 1 BLINK_ON - the LED blinks on every 10ms when activity is
15 2 BLINK_OFF - the LED is on when idle, and blinks off
|
| /linux-6.14.4/drivers/leds/trigger/ |
| D | ledtrig-netdev.c | 40 * tx - LED blinks on transmitted data
41 * rx - LED blinks on receive data
42 * tx_err - LED blinks on transmit error
43 * rx_err - LED blinks on receive error
|
| D | Kconfig | 28 or on dense events, where this blinks the LED at constant rate if
|
| /linux-6.14.4/Documentation/devicetree/bindings/leds/ |
| D | nxp,pca963x.yaml | 54 In some configurations, the chip blinks faster than expected. This
|
| /linux-6.14.4/sound/pcmcia/pdaudiocf/ |
| D | pdaudiocf.h | 64 #define PDAUDIOCF_HALFRATE (1<<15) /* slow both LED blinks by half (also spdif detect rate) */
|
| /linux-6.14.4/include/uapi/linux/usb/ |
| D | ch11.h | 293 /* software blinks for attention: software, hardware, reserved */
|
| /linux-6.14.4/drivers/net/wireless/realtek/rtl818x/rtl8187/ |
| D | leds.c | 123 /* The LED is off for 1/20 sec - it just blinks. */ in rtl8187_led_brightness_set()
|
| /linux-6.14.4/include/linux/ |
| D | leds.h | 230 * Get the device this LED blinks in response to.
347 * If invert is set, led blinks for delay_off first, then for
|
| /linux-6.14.4/drivers/macintosh/ |
| D | Kconfig | 96 so that it blinks on disk activity.
|
| /linux-6.14.4/Documentation/fb/ |
| D | matroxfb.rst | 211 noblink disables cursor blinking. Cursor in text mode always blinks (hw
|
| /linux-6.14.4/drivers/scsi/aic94xx/ |
| D | aic94xx_scb.c | 622 * - an LED blinks if there is IO though it,
|
| /linux-6.14.4/drivers/scsi/bfa/ |
| D | bfi.h | 1071 u16 freq; /* no. of blinks every 10 secs */
|
| D | bfa_defs.h | 1229 u16 freq; /* no. of blinks every 10 secs */
|
| D | bfa_ioc.c | 4942 * convert the freq from N blinks per 10 sec to in diag_ledtest_send()
|
| /linux-6.14.4/scripts/ |
| D | get_maintainer.pl | 750 ($self_test eq "" || $self_test =~ /\blinks\b/)) {
|
| /linux-6.14.4/drivers/infiniband/hw/qib/ |
| D | qib_iba6120.c | 1425 * Mellanox further blinks the amber LED to indicate data packet
|
| D | qib_iba7220.c | 1718 * Mellanox further blinks the amber LED to indicate data packet
|
| D | qib_iba7322.c | 2586 * Mellanox further blinks the amber LED to indicate data packet
|