Home
last modified time | relevance | path

Searched +full:bldoin +full:- +full:supply (Results 1 – 9 of 9) sorted by relevance

/linux-6.14.4/drivers/regulator/
Daxp20x-regulator.c361 .n_voltages = (((_max) - (_min)) / (_step) + 1), \
383 .n_voltages = (((_max) - (_min)) / (_step) + 1), \
467 switch (axp20x->variant) { in axp20x_set_ramp_delay()
497 return -ENOTSUPP; in axp20x_set_ramp_delay()
516 dev_err(axp20x->dev, "unsupported ramp value %d", ramp); in axp20x_set_ramp_delay()
517 return -EINVAL; in axp20x_set_ramp_delay()
523 return regmap_update_bits(axp20x->regmap, reg, mask, cfg); in axp20x_set_ramp_delay()
531 switch (axp20x->variant) { in axp20x_regulator_enable_regmap()
534 rdev->constraints && rdev->constraints->soft_start) { in axp20x_regulator_enable_regmap()
771 AXP_DESC_FIXED(AXP313A, RTC_LDO, "rtc-ldo", "vin1", 1800),
[all …]
/linux-6.14.4/arch/arm64/boot/dts/allwinner/
Dsun50i-h616-orangepi-zero2.dts1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 /dts-v1/;
8 #include "sun50i-h616-orangepi-zero.dtsi"
9 #include "sun50i-h616-cpu-opp.dtsi"
13 compatible = "xunlong,orangepi-zero2", "allwinner,sun50i-h616";
17 cpu-supply = <&reg_dcdca>;
21 allwinner,rx-delay-ps = <3100>;
22 allwinner,tx-delay-ps = <700>;
23 phy-mode = "rgmii";
24 phy-supply = <&reg_dcdce>;
[all …]
Dsun50i-h616-x96-mate.dts1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 /dts-v1/;
8 #include "sun50i-h616.dtsi"
9 #include "sun50i-h616-cpu-opp.dtsi"
11 #include <dt-bindings/gpio/gpio.h>
12 #include <dt-bindings/interrupt-controller/arm-gic.h>
16 compatible = "hechuang,x96-mate", "allwinner,sun50i-h616";
23 stdout-path = "serial0:115200n8";
27 /* board wide 5V supply directly from the DC input */
28 compatible = "regulator-fixed";
[all …]
Dsun50i-h6-orangepi.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
5 /dts-v1/;
7 #include "sun50i-h6.dtsi"
9 #include <dt-bindings/gpio/gpio.h>
13 compatible = "xunlong,orangepi-one-plus", "allwinner,sun50i-h6";
20 stdout-path = "serial0:115200n8";
24 compatible = "hdmi-connector";
26 ddc-en-gpios = <&pio 7 2 GPIO_ACTIVE_HIGH>; /* PH2 */
30 remote-endpoint = <&hdmi_out_con>;
35 ext_osc32k: ext-osc32k-clk {
[all …]
Dsun50i-h6-beelink-gs1.dts1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
4 /dts-v1/;
6 #include "sun50i-h6.dtsi"
7 #include "sun50i-h6-cpu-opp.dtsi"
8 #include "sun50i-h6-gpu-opp.dtsi"
10 #include <dt-bindings/gpio/gpio.h>
14 compatible = "azw,beelink-gs1", "allwinner,sun50i-h6";
22 stdout-path = "serial0:115200n8";
26 compatible = "hdmi-connector";
28 ddc-en-gpios = <&pio 7 2 GPIO_ACTIVE_HIGH>; /* PH2 */
[all …]
Dsun50i-h6-orangepi-3.dts1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
4 /dts-v1/;
6 #include "sun50i-h6.dtsi"
7 #include "sun50i-h6-cpu-opp.dtsi"
9 #include <dt-bindings/gpio/gpio.h>
13 compatible = "xunlong,orangepi-3", "allwinner,sun50i-h6";
21 stdout-path = "serial0:115200n8";
25 compatible = "hdmi-connector";
26 ddc-en-gpios = <&pio 7 2 GPIO_ACTIVE_HIGH>; /* PH2 */
31 remote-endpoint = <&hdmi_out_con>;
[all …]
/linux-6.14.4/Documentation/devicetree/bindings/mfd/
Dx-powers,axp152.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/mfd/x-powers,axp152.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: X-Powers AXP PMIC
10 - Chen-Yu Tsai <[email protected]>
13 - if:
18 - x-powers,axp152
19 - x-powers,axp202
20 - x-powers,axp209
[all …]
/linux-6.14.4/arch/arm/boot/dts/allwinner/
Dsun9i-a80-cubieboard4.dts5 * Chen-Yu Tsai <[email protected]>
7 * This file is dual-licensed: you can use it either under the terms
46 /dts-v1/;
47 #include "sun9i-a80.dtsi"
49 #include <dt-bindings/gpio/gpio.h>
53 compatible = "cubietech,a80-cubieboard4", "allwinner,sun9i-a80";
60 stdout-path = "serial0:115200n8";
64 compatible = "gpio-leds";
66 led-0 {
71 led-1 {
[all …]
Dsun9i-a80-optimus.dts2 * Copyright 2014 Chen-Yu Tsai
4 * Chen-Yu Tsai <[email protected]>
6 * This file is dual-licensed: you can use it either under the terms
45 /dts-v1/;
46 #include "sun9i-a80.dtsi"
48 #include <dt-bindings/gpio/gpio.h>
52 compatible = "merrii,a80-optimus", "allwinner,sun9i-a80";
60 stdout-path = "serial0:115200n8";
64 compatible = "gpio-leds";
83 reg_usb1_vbus: usb1-vbus {
[all …]