Searched full:allowable (Results 1 – 25 of 126) sorted by relevance
123456
33 * @pllm_min: Minimum allowable value for PLLM[PLLM]34 * @pllm_max: Maximum allowable value for PLLM[PLLM]35 * @pllout_min_rate: Minimum allowable rate for PLLOUT36 * @pllout_max_rate: Maximum allowable rate for PLLOUT
18 This is an integer and represents allowable DMA bursts when fixed burst.19 Allowable range is 0x01-0x3F. When this field is set fixed burst is enabled.20 When fixed length is needed for burst mode, it can be set within allowable
29 allowable by a module in the slot, in milli-Watts. Presently, modules can
12 Reading returns the allowable voltage range for26 Reading returns the allowable voltage range for
200 * @lo: lowest allowable value201 * @hi: highest allowable value212 * @lo: minimum allowable value213 * @hi: maximum allowable value223 * @lo: minimum allowable value224 * @hi: maximum allowable value
11 * @read_write_len_ext: Allowable additional number of byte octets to the LPL66 * @read_write_len_ext: Allowable additional number of byte octets to the LPL
10 /* For accessing the LPL field on page 9Fh, the allowable length extension is11 * min(i, 15) byte octets where i specifies the allowable additional number of
200 int "Clocksource watchdog maximum allowable skew (in microseconds)"205 Specify the maximum amount of allowable watchdog skew in
6 * may_use_simd - whether it is allowable at this time to issue SIMD
374 "Description": "Setting generous range for allowable frequencies",389 "Description": "Setting generous range for allowable frequencies",
18 * may_use_simd - whether it is allowable at this time to issue SIMD
455 * @min_freq_hz: The minimum allowable frequency in Hz. This is the minimum456 * allowable programmed frequency and does not account for clock460 * @max_freq_hz: The maximum allowable frequency in Hz. This is the maximum461 * allowable programmed frequency and does not account for clock502 * @min_freq_hz: The minimum allowable frequency in Hz. This is the minimum503 * allowable programmed frequency and does not account for clock507 * @max_freq_hz: The maximum allowable frequency in Hz. This is the maximum508 * allowable programmed frequency and does not account for clock518 * This sets the desired frequency for a clock within an allowable
15 Allowable values of 0x00 through 0x0F. These are raw values written to the
18 Allowable values of 0x00 through 0x0F. These are raw values written to the
158 * -min_freq: The minimum allowable frequency in Hz. This is the minimum159 * allowable programmed frequency and does not account for clock163 * -max_freq: The maximum allowable frequency in Hz. This is the maximum164 * allowable programmed frequency and does not account for clock
39 * @max_core_clk_rate: maximum allowable core clock rate
21 * may_use_simd - whether it is allowable at this time to issue vector
49 /* Powerdomain allowable state bitfields */
18 /* Max number of segments allowable in LUX table */
5 * linkmode_resolve_pause - resolve the allowable pause modes
31 /* The maximum allowable size of the index */
292 uint16_t MaxVoltageGfx; // In mV(Q2) Maximum Voltage allowable of VDD_GFX293 uint16_t MaxVoltageSoc; // In mV(Q2) Maximum Voltage allowable of VDD_SOC
59 * Max allowable width is limited on a per device basis
63 * @timeout: maximum allowable time in jiffies between start I/O and interrupt