Home
last modified time | relevance | path

Searched full:wilink (Results 1 – 14 of 14) sorted by relevance

/linux-6.14.4/drivers/net/wireless/ti/wl1251/
Dacx.h53 * The WiLink firmware version, an ASCII string x.x.x.x,
69 * This 4 byte field specifies the WiLink hardware version.
71 * bits 16 - 23: Version ID - The WiLink version ID
73 * bits 24 - 31: Chip ID - The WiLink chip ID.
198 * 10 SSID Filter Enable - When set, the WiLink discards all beacon,
202 * When clear, the WiLink receives frames with any SSID.
203 * 9 Broadcast Filter Enable - When set, the WiLink discards all
204 * broadcast frames. When clear, the WiLink receives all received
207 * 5 BSSID Filter Enable - When set, the WiLink discards any frames
210 * When clear, the WiLink receives frames from any BSSID.
[all …]
Dcmd.h121 * The host issues this command to read the WiLink device memory/registers.
129 * The host issues this command to write the WiLink device memory/registers.
142 /* The amount of data in bytes to read from or write to the WiLink
146 /* The actual value read from or written to the Wilink. The source
147 of this field is the Host in WRITE command or the Wilink in READ
Dreg.h584 Interrupt Trigger Register (Host -> WiLink)
/linux-6.14.4/Documentation/devicetree/bindings/net/bluetooth/
Dti,bluetooth.yaml18 * TI WiLink 7/8 (wl12xx/wl18xx) Shared Transport BT/FM/GPS devices
20 TI WiLink devices have a UART interface for providing Bluetooth, FM radio,
24 TI WiLink devices also have a separate WiFi interface as described in
/linux-6.14.4/drivers/net/wireless/ti/wl18xx/
DKconfig8 WiLink 8 chipsets.
Dmain.c2156 MODULE_DESCRIPTION("TI WiLink 8 wireless driver");
/linux-6.14.4/Documentation/devicetree/bindings/net/wireless/
Dti,wlcore.yaml7 title: Texas Instruments Wilink 6/7/8 (wl12xx/wl18xx) Wireless LAN Controller
/linux-6.14.4/drivers/net/wireless/ti/wl12xx/
Dwl12xx.h13 /* WiLink 6/7 chip IDs */
/linux-6.14.4/drivers/net/wireless/ti/wlcore/
Dacx.h19 Host Interrupt Register (WiLink -> Host)
389 * When set, the WiLink transmits the frames with a short preamble and
390 * when cleared, the WiLink transmits the frames with a long preamble.
Dsdio.c385 dev_err(dev, "no wilink module was probed\n"); in wl1271_suspend()
Dspi.c170 * by the wilink family in order to successfully enter WSPI mode. in wl12xx_spi_init()
Dwlcore.h592 Interrupt Trigger Register (Host -> WiLink)
/linux-6.14.4/include/linux/
Dti_wilink_st.h18 * enum proto-type - The protocol on WiLink chips which share a
/linux-6.14.4/
DMAINTAINERS23913 TI WILINK WIRELESS DRIVERS