Searched full:vybrid (Results 1 – 25 of 29) sorted by relevance
12
| /linux-6.14.4/Documentation/devicetree/bindings/pinctrl/ |
| D | fsl,vf610-pinctrl.txt | 1 Freescale Vybrid VF610 IOMUX Controller
11 such as pull-up, speed, ode for this pin. Please refer to Vybrid VF610
41 for all available PIN_FUNC_ID for Vybrid VF610.
|
| /linux-6.14.4/drivers/irqchip/ |
| D | irq-vf610-mscm-ir.c | 6 * IRQ chip driver for MSCM interrupt router available on Vybrid SoC's.
9 * one of the two available CPU's on Vybrid VF6xx SoC's (Cortex-A5 or
13 * o All peripheral interrupts of the Vybrid SoC can be routed to
15 * variants of Vybrid SoC such as VF6xx. This driver routes the
19 * variants of Vybrid.
|
| /linux-6.14.4/Documentation/devicetree/bindings/nvmem/ |
| D | vf610-ocotp.txt | 1 On-Chip OTP Memory for Freescale Vybrid
11 Example for Vybrid VF5xx/VF6xx:
|
| /linux-6.14.4/Documentation/devicetree/bindings/arm/freescale/ |
| D | fsl,vf610-mscm-ir.txt | 1 Freescale Vybrid Miscellaneous System Control - Interrupt Router
7 Vybrid SoC's but is only really useful in dual core configurations (VF6xx
|
| /linux-6.14.4/Documentation/devicetree/bindings/mtd/ |
| D | vf610-nfc.txt | 4 Vybrid (vf610), MPC5125, MCF54418 and Kinetis K70.
12 - assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>;
|
| /linux-6.14.4/drivers/iio/dac/ |
| D | vf610_dac.c | 3 * Freescale Vybrid vf610 DAC driver
131 * reference voltage as per Vybrid datasheet is 3.3V in vf610_read_raw()
132 * from section 9.1.2.1 of Vybrid datasheet in vf610_read_raw()
|
| D | Kconfig | 574 tristate "Vybrid vf610 DAC driver"
577 Say yes here to support Vybrid board digital-to-analog converter.
|
| /linux-6.14.4/arch/arm/mach-imx/ |
| D | Kconfig | 224 bool "Vybrid Family VF610 support"
228 This enables support for Freescale Vybrid VF610 processor.
|
| D | mach-vf610.c | 66 DT_MACHINE_START(VYBRID_VF610, "Freescale Vybrid VF5xx/VF6xx (Device Tree)")
|
| /linux-6.14.4/drivers/pinctrl/freescale/ |
| D | Kconfig | 247 bool "Freescale Vybrid VF610 pinctrl driver"
253 Say Y here to enable the Freescale Vybrid VF610 pinctrl driver
|
| /linux-6.14.4/drivers/mtd/nand/raw/ |
| D | vf610_nfc.c | 218 * Freescale Vybrid SoC it's known that the driver can treat
223 * endianness. On little endian platforms such as Vybrid this leads
253 * Freescale Vybrid SoC it's known that the driver can treat
258 * endianness. On little endian platforms such as Vybrid this leads
478 * This function supports Vybrid only (MPC5125 would have full RB and four CS)
485 /* Vybrid only (MPC5125 would have full RB and four CS) */ in vf610_nfc_select_target()
|
| /linux-6.14.4/Documentation/devicetree/bindings/clock/ |
| D | vf610-clock.txt | 1 * Clock bindings for Freescale Vybrid VF610 SOC
|
| /linux-6.14.4/Documentation/devicetree/bindings/pwm/ |
| D | fsl,vf610-ftm-pwm.yaml | 17 Vybrid | LE
|
| /linux-6.14.4/drivers/nvmem/ |
| D | vf610-ocotp.c | 253 MODULE_DESCRIPTION("Vybrid OCOTP driver");
|
| D | Kconfig | 403 This is a driver for the 'OCOTP' peripheral available on Vybrid
|
| /linux-6.14.4/drivers/iio/adc/ |
| D | vf610_adc.c | 3 * Freescale Vybrid vf610 ADC driver
33 /* Vybrid/IMX ADC registers */
|
| D | Kconfig | 1639 Say yes here to support for Vybrid board analog-to-digital converter.
|
| /linux-6.14.4/arch/arm/ |
| D | Kconfig.debug | 1321 bool "Vybrid UART"
1325 on Vybrid based platforms.
1453 int "Vybrid Debug UART Port Selection" if DEBUG_VF_UART
|
| /linux-6.14.4/drivers/i2c/busses/ |
| D | i2c-imx.c | 109 * - but write one to clear(w1c) INT flag on Vybrid.
112 * - but clear I2CR_IEN bit enable the module on Vybrid.
150 /* Vybrid VF610 clock divider, register value pairs */
385 * toggled. This is required because i.MX needs W0C and Vybrid uses W1C. in i2c_imx_clear_irq()
|
| /linux-6.14.4/drivers/clocksource/ |
| D | Kconfig | 473 Support for Periodic Interrupt Timer on Freescale Vybrid Family SoCs.
|
| /linux-6.14.4/drivers/dma/ |
| D | Kconfig | 220 This module can be found on Freescale Vybrid and LS-1 SoCs.
|
| D | fsl-edma-main.c | 10 * Vybrid, Layerscape and S32G SoCs.
|
| D | fsl-edma-common.c | 888 * On the 32 channels Vybrid/mpc577x edma version, register offsets are
|
| /linux-6.14.4/Documentation/devicetree/bindings/arm/ |
| D | fsl.yaml | 1411 Freescale Vybrid Platform Device Tree Bindings
1413 For the Vybrid SoC family all variants with DDR controller are supported,
|
| /linux-6.14.4/drivers/usb/chipidea/ |
| D | usbmisc_imx.c | 586 * Vybrid only has one misc register set, but in two different in usbmisc_vf610_init()
|
12