Searched full:pulsewidth (Results 1 – 6 of 6) sorted by relevance
| /linux-6.14.4/tools/testing/selftests/ptp/ |
| D | testptp.c | 198 int64_t pulsewidth = -1; in main() local
269 pulsewidth = atoi(optarg); in main()
487 if (pulsewidth >= 0 && perout < 0) { in main()
507 if (pulsewidth >= 0) { in main()
509 perout_request.on.sec = pulsewidth / NSEC_PER_SEC; in main()
510 perout_request.on.nsec = pulsewidth % NSEC_PER_SEC; in main()
|
| /linux-6.14.4/Documentation/devicetree/bindings/ptp/ |
| D | fsl,ptp.yaml | 96 PulseWidth = 1 / OutputClock microseconds
|
| /linux-6.14.4/drivers/net/phy/ |
| D | microchip_rds_ptp.c | 225 int ret, event_pin, pulsewidth; in mchp_rds_ptp_perout() local
244 ret = mchp_get_pulsewidth(phydev, perout, &pulsewidth); in mchp_rds_ptp_perout()
249 ret = mchp_general_event_config(clock, pulsewidth); in mchp_rds_ptp_perout()
|
| /linux-6.14.4/drivers/iio/adc/ |
| D | ti-ads1298.c | 708 * Minimum reset pulsewidth is 2 clock cycles. in ads1298_probe()
|
| /linux-6.14.4/drivers/media/dvb-frontends/ |
| D | dib7000p.c | 2507 u16 pulseWidth, u16 enSerialMode, u16 enSerialClkDiv2) in dib7090_configMpegMux() argument
2517 dib7000p_write_word(state, 1287, ((pulseWidth & 0x1f) << 2) in dib7090_configMpegMux()
|
| D | dib8000.c | 1459 u16 pulseWidth, u16 enSerialMode, u16 enSerialClkDiv2) in dib8096p_configMpegMux() argument
1471 reg_1287 = ((pulseWidth & 0x1f) << 3) | in dib8096p_configMpegMux()
|