Searched full:en2 (Results 1 – 14 of 14) sorted by relevance
| /linux-6.14.4/Documentation/devicetree/bindings/iio/adc/ |
| D | adi,ad7625.yaml | 82 adi,en2-always-on:
85 Indicates if EN2 is hard-wired to the high state. If neither this
86 nor en2-gpios are present, then EN2 is hard-wired low.
102 en2-gpios:
104 Configurable EN2 pin.
142 en2-gpios: false
144 adi,en2-always-on: false
|
| /linux-6.14.4/Documentation/devicetree/bindings/net/nfc/ |
| D | ti,trf7970a.yaml | 27 en2-rf-quirk:
30 Specify that the trf7970a being used has the "EN2 RF" erratum
47 One or two GPIO entries used for 'EN' and 'EN2' pins on the TRF7970A. EN2
96 en2-rf-quirk;
|
| /linux-6.14.4/drivers/iio/adc/ |
| D | ad7625.c | 85 * EN2 controls the device -3dB bandwidth (and by extension, max
86 * sample rate). EN3 controls the VCM reference output. EN2 and
322 * Bandwidth (AD796x) is controlled solely by EN2. If it's in ad7625_parse_mode()
327 /* Wide bandwidth mode is possible if EN2 can be 0. */ in ad7625_parse_mode()
638 * AD796x device is limited to narrow bandwidth by EN2 == 1, in in ad7625_probe()
|
| /linux-6.14.4/drivers/nfc/ |
| D | trf7970a.c | 32 * The trf7970a is very timing sensitive and the VIN, EN2, and EN
36 * version of the trf7970a that requires that EN2 remain low no matter
39 * when EN2 is left low. The 'en2-rf-quirk' device tree property
41 * that EN2 must be kept low.
2033 dev_info(trf->dev, "No EN2 GPIO property\n"); in trf7970a_probe()
2035 dev_err(trf->dev, "Error getting EN2 GPIO property: %ld\n", in trf7970a_probe()
2038 } else if (of_property_read_bool(np, "en2-rf-quirk")) { in trf7970a_probe()
|
| /linux-6.14.4/arch/arm/boot/dts/nxp/imx/ |
| D | imx6dl-prtrvt.dts | 72 en2-rf-quirk;
|
| /linux-6.14.4/Documentation/devicetree/bindings/mfd/ |
| D | max77620.txt | 42 register to have a hardware enable source (EN1 or EN2) or a software enable
|
| D | tps65910.txt | 71 control through external inputs [0 (not enabled), 1 (EN1), 2 (EN2) or 4(EN3)]
|
| /linux-6.14.4/arch/mips/include/asm/octeon/ |
| D | cvmx-lmcx-defs.h | 2132 uint64_t en2:1; member
2134 uint64_t en2:1;
2164 uint64_t en2:1; member
2166 uint64_t en2:1;
2194 uint64_t en2:1; member
2196 uint64_t en2:1;
|
| /linux-6.14.4/drivers/regulator/ |
| D | tps65910-regulator.c | 830 * Regulator can not be control from multiple external input EN1, EN2 in tps65910_set_ext_sleep_config()
865 /* External EN2 control */ in tps65910_set_ext_sleep_config()
874 "Error in configuring external control EN2\n"); in tps65910_set_ext_sleep_config()
|
| /linux-6.14.4/drivers/mtd/maps/ |
| D | esb2rom.c | 38 /* This became a 16-bit register, and EN2 has disappeared */
|
| /linux-6.14.4/arch/arm64/boot/dts/qcom/ |
| D | sa8155p-adp.dts | 547 usb2phy_ac_en2_default: usb2phy-ac-en2-default-state {
|
| /linux-6.14.4/include/linux/mfd/ |
| D | tps65910.h | 845 /* External sleep controls through EN1/EN2/EN3/SLEEP inputs */
|
| /linux-6.14.4/arch/arm/boot/dts/nvidia/ |
| D | tegra124-apalis-v1.2.dtsi | 411 usb-vbus-en2-pff1 { /* D7 GPIO */
|
| D | tegra124-apalis.dtsi | 408 usb-vbus-en2-pff1 { /* D7 GPIO */
|