Searched full:brom (Results 1 – 7 of 7) sorted by relevance
| /linux-6.14.4/Documentation/devicetree/bindings/sram/ |
| D | sram.yaml | 273 // value is set at a specific location. If it is then the BROM will jump
287 // This is checked by BROM to determine if
|
| /linux-6.14.4/drivers/gpu/drm/nouveau/nvkm/falcon/ |
| D | ga100.c | 38 FLCN_DBG(falcon, "brom: %08x %08x", fw->engine_id, fw->ucode_id); in ga100_flcn_fw_signature()
|
| /linux-6.14.4/drivers/gpu/drm/nouveau/nvkm/subdev/gsp/ |
| D | ga102.c | 103 FLCN_DBG(falcon, "brom: %08x %08x", fw->engine_id, fw->ucode_id); in ga102_gsp_fwsec_signature()
|
| /linux-6.14.4/drivers/usb/mtu3/ |
| D | mtu3_plat.c | 185 * device ip may be powered on in firmware/BROM stage before entering in ssusb_ip_sw_reset()
|
| /linux-6.14.4/drivers/clk/thead/ |
| D | clk-th1520-ap.c | 789 static CCU_GATE(CLK_BROM, brom_clk, "brom", ahb2_cpusys_hclk_pd, 0x100, BIT(4), 0);
|
| /linux-6.14.4/arch/arm/boot/dts/allwinner/ |
| D | sun9i-a80.dtsi | 313 * This is checked by BROM to determine if
|
| /linux-6.14.4/drivers/misc/bcm-vk/ |
| D | bcm_vk_dev.c | 1473 "Auto-load skipped - BROM not in proper state (0x%x)\n", in bcm_vk_probe()
|