232  * space for 267 bytes of scratch. I used 268 bytes since not sure if this
542      * NOTE: since the counter can tick 1 while we do these calculations we  in ble_phy_set_start_time()
611      * than what we expect. Since this is only used on RX, it may cause AUX scan  in ble_phy_set_start_now()
652          * cycle and since wfr expires at the beginning of calculated timer  in ble_phy_wfr_enable()
672          * Do not add jitter since this is already covered by LL.  in ble_phy_wfr_enable()
683     /* Adjust for receiving access address since this triggers EVENT_ADDRESS */  in ble_phy_wfr_enable()
704      * Note that the same applies to RX start time set in CC[0] but since it  in ble_phy_wfr_enable()
929      * For Coded PHY mode can be set to either codings since actual coding is  in ble_phy_get_cur_rx_phy_mode()
1040      * for TX to start since EVENTS_COMPARE[0] will not happen any time soon.  in ble_phy_rx_end_isr()
1292      * of conflict with GPIO setup via hal. It's not great solution, but since  in ble_phy_dbg_time_setup()
1359      * XXX: I do not think we need to wait for settling time here since  in ble_phy_init()
1479      * any reason it's just in idle state we proceed with RX as usual since  in ble_phy_rx()
1586     /* Clear timer0 compare to RXEN since we are transmitting */  in ble_phy_tx_set_start_time()
1623     /* Clear timer0 compare to TXEN since we are transmitting */  in ble_phy_rx_set_start_time()