42  * and 16ms for a 30ppm crystal! We need to limit PDU size based on
319      * Need to look at this.  in ble_phy_set_start_time()
323      * With the 32.768 kHz crystal, we may need to adjust the RTC compare  in ble_phy_set_start_time()
327      * TIMER0 counts at 1MHz). A remainder of 19 or more we will need to add  in ble_phy_set_start_time()
328      * 1 tick. We dont need to add 1 tick per se, but it does give us slightly  in ble_phy_set_start_time()
349      * need to account for it.  in ble_phy_set_start_time()
476             /* XXX: do I only need to do this once? Figure out what I can do  in ble_phy_rx_xcvr_setup()
519     /* If this transmission was encrypted we need to remember it */  in ble_phy_tx_end_isr()
567          * XXX: not sure we need to stop the timer here all the time. Or that  in ble_phy_tx_end_isr()
628              * encrypted we need to not trust this frame and drop it.  in ble_phy_rx_end_isr()
729         /* Must start aar if we need to  */  in ble_phy_rx_start_isr()
826      * XXX: I do not think we need to wait for settling time here since  in ble_phy_init()
1050      * Need to look at this.  in ble_phy_tx_set_start_time()
1089      * Need to look at this.  in ble_phy_rx_set_start_time()