Lines Matching +full:hardware +full:- +full:driven

1 /* SPDX-License-Identifier: GPL-2.0-only */
5  * Copyright (C) 2011 ST-Ericsson SA
6  * Written on behalf of Linaro for ST-Ericsson
24  * enum pin_config_param - possible pin configuration parameters
31  *	transition from say pull-up to pull-down implies that you disable
32  *	pull-up in the process, this setting disables all biasing.
34  *	mode, also know as "third-state" (tristate) or "high-Z" or "floating".
40  *	impedance to GROUND). If the argument is != 0 pull-down is enabled,
44  *	on embedded knowledge of the controller hardware, like current mux
46  *	be decided completely inside the hardware block and not be readable
52  *	impedance to VDD). If the argument is != 0 pull-up is enabled,
55  * @PIN_CONFIG_DRIVE_OPEN_DRAIN: the pin will be driven with open drain (open
59  * @PIN_CONFIG_DRIVE_OPEN_SOURCE: the pin will be driven with open source
62  * @PIN_CONFIG_DRIVE_PUSH_PULL: the pin will be driven actively high and
65  *	push-pull mode, the argument is ignored.
78  *	schmitt-trigger mode. If the schmitt-trigger has adjustable hysteresis,
81  * @PIN_CONFIG_INPUT_SCHMITT_ENABLE: control schmitt-trigger mode on the pin.
82  *      If the argument != 0, schmitt-trigger mode is enabled. If it's 0,
83  *      schmitt-trigger mode is disabled.
85  *	schmitt-trigger mode. The argument is in uV.
93  *	indicate low level. (Please see Documentation/driver-api/pin-control.rst,