Lines Matching +full:port +full:- +full:config
1 # SPDX-License-Identifier: GPL-2.0
7 config USB_USS720
12 This driver is for USB parallel port adapters that use the Lucent
13 Technologies USS-720 chip. These cables are plugged into your USB
14 port and provide USB compatibility to peripherals designed with
15 parallel port interfaces.
19 printers may be connected to the USS-720 in this mode. The generic
24 Manual mode is not limited to printers, any parallel port
27 slower than on a PCI/ISA Parallel Port, so timing critical
30 Say Y here if you own an USS-720 USB->Parport cable and intend to
36 config USB_EMI62
50 config USB_EMI26
62 config USB_ADUTUX
71 config USB_SEVSEG
72 tristate "USB 7-Segment LED Display"
74 Say Y here if you have a USB 7-Segment Display by Delcom
79 config USB_LEGOTOWER
83 computer's USB port.
91 config USB_LCD
95 USB port. The USBLCD is a small USB interface board for
102 config USB_CYPRESS_CY7C63
106 micro controller to your computer's USB port. Currently this
107 driver supports the pre-programmed devices (incl. firmware)
108 by AK Modul-Bus Computer GmbH.
110 Please see: https://www.ak-modul-bus.de/stat/mikrocontroller.html
115 config USB_CYTHERM
119 device to your computer's USB port. This device is also known
127 config USB_IDMOUSE
140 config USB_APPLEDISPLAY
147 config USB_QCOM_EUD
154 which reports VBUS attach/detach events and has USB-based
158 config APPLE_MFI_FASTCHARGE
168 config USB_LJCA
173 This adds support for Intel La Jolla Cove USB-I2C/SPI/GPIO
179 will be called usb-ljca.
183 config USB_LD
192 config USB_TRANCEVIBRATOR
196 device to your computer's USB port.
201 config USB_IOWARRIOR
214 config USB_TEST
221 See <http://www.linux-usb.org/usbtest/> for more information,
224 config USB_EHSET_TEST_FIXTURE
228 used for the USB-IF Embedded Host High-Speed Electrical Test procedure.
232 the downstream port to which the test fixture is attached.
237 config USB_ISIGHTFW
243 http://linux-uvc.berlios.de
249 config USB_YUREX
253 USB port. The YUREX is a leg-shakes sensor. See
255 This driver supports read/write of leg-shakes counter and
261 config USB_EZUSB_FX2
267 config USB_HUB_USB251XB
276 config USB_HSIC_USB3503
283 config USB_HSIC_USB4604
289 config USB_LINK_LAYER_TEST
296 config USB_CHAOSKEY
301 Araneus Alea I to your computer's USB port. These devices
310 config BRCM_USB_PINMAP
319 config USB_ONBOARD_DEV
325 but need some non-trivial form of initialization, such as
331 this config will enable the driver and it will automatically
335 config USB_ONBOARD_DEV_USB5744
343 during hub start-up configuration stage. It is must to enable this
345 connected to USB-SD converter which mounts the root filesystem.