Lines Matching +full:zynqmp +full:- +full:qspi +full:- +full:1
1 # SPDX-License-Identifier: GPL-2.0-only
13 dynamic device discovery; some are even write-only or read-only.
17 chips, analog to digital (and d-to-a) converters, and more.
44 If your system has an master-capable SPI controller (which
56 by providing a high-level interface to send memory-like commands.
66 This enables support for SPI-NAND mode on the Airoha NAND
68 is implemented as a SPI-MEM controller.
107 to a single device like spi-nor (nvram), input device controller
166 supports spi-mem interface.
245 this code to manage the per-word or per-transfer accesses to the
266 used by Xilinx Zynq and ZynqMP.
274 Cadence QSPI is a specialized controller for connecting an SPI
275 Flash over 1/2/4-bit wide bus. Enable this option if you have a
276 device with a Cadence QSPI controller and want to access the
287 Flash over up to 8-bit wide bus. Enable this option if you have a
301 This enables dedicated general purpose SPI/Microwire1-compatible
302 master mode interface (SSI1) for CLPS711X-based CPUs.
305 tristate "Freescale Coldfire QSPI controller"
308 This enables support for the Coldfire QSPI controller in master
320 tristate "Texas Instruments DaVinci/DA8x/OMAP-L/AM1x SoC SPI controller"
324 SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules.
342 tristate "Memory-mapped io interface driver for DW SPI core"
346 tristate "Baikal-T1 SPI driver for DW SPI core"
350 Baikal-T1 SoC is equipped with three DW APB SSI-based MMIO SPI
353 part of the Baikal-T1 System Boot Controller has got a very
355 chip-select and Tx/Rx FIFO with just 8 words depth available.
356 The later one is normally connected to an external SPI-nor flash
360 bool "Directly mapped Baikal-T1 Boot SPI flash support"
364 Baikal-T1 System Boot Controller. It is a 16MB MMIO region, which
369 time-critical tasks (like the SPI memory operations implemented
375 tristate "Diolan DLN-2 USB SPI adapter"
382 will be called spi-dln2.
395 The external bus unit (EBU) found on the FALC-ON SoC has SPI
414 tristate "Freescale QSPI controller"
422 supports the high-level SPI memory interface.
439 will be called hisi-kunpeng-spi.
458 supports the high-level SPI memory interface.
461 tristate "GPIO-based bitbanging SPI Master"
465 This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
471 Note that this driver often won't achieve even 1 Mbit/sec speeds,
496 will be called spi-ingenic.
517 will be called spi-intel-pci.
529 exposes the low level SPI-NOR opcodes to the software. Using
536 will be called spi-intel-platform.
539 tristate "J-Core SPI Master"
542 This enables support for the SPI master controller in the J-Core
555 will be called spi-kspi2.
593 tristate "ICP DAS LP-8841 SPI Controller for RTC"
597 DS-1302 real time clock.
600 LP-8x4x industrial computer.
603 tristate "Freescale MPC52xx SPI (non-PSC) controller support"
668 will be called spi-ljca.
693 If built as a module, it will be called spi-microchip-core.
696 tristate "Microchip FPGA QSPI controllers"
699 This enables the QSPI driver for Microchip FPGA QSPI controllers.
700 Say Y or M here if you want to use the QSPI controllers on
702 If built as a module, it will be called spi-microchip-core-qspi.
734 This enables support for SPI-NAND mode on the MediaTek NAND
736 is implemented as a SPI-MEM controller with pipelined ECC
748 supports the spi-mem interface.
758 supports spi-mem interface.
805 tristate "DRA7xxx QSPI controller support"
808 QSPI master controller for DRA7xxx used for flash devices.
826 called as spi-pci1xxxx.
870 tristate "Realtek SPI-NAND Flash Controller"
874 This enables support for the SPI-NAND Flash controller on
878 only supports the spi-mem interface.
911 tristate "Renesas RPC-IF SPI driver"
914 SPI driver for Renesas R-Car Gen3 or RZ/G2 RPC-IF.
917 tristate "Renesas RSPI/QSPI controller"
920 SPI driver for Renesas RSPI and QSPI blocks.
930 tristate "QTI QSPI controller"
933 QSPI(Quad SPI) driver for Qualcomm QSPI controller.
941 for serial peripheral interface (SPI) mini-core. SPI in master
954 yes to this option, support will be included for the built-in SPI
958 will be called spi-geni-qcom.
1021 for connecting an SPI Flash memory over up to 8-bit wide bus.
1056 supports spi-mem interface.
1059 tristate "STMicroelectronics SPI SSC-based driver"
1084 called as spi-sunplus-sp7021.
1095 that use the de-facto standard SPI protocol.
1097 It also supports the new dual-bit and quad-bit SPI protocol.
1114 tristate "NVIDIA Tegra QSPI Controller"
1118 QSPI driver for NVIDIA Tegra QSPI Controller interface. This
1179 tristate "Analog Devices AD-FMCOMMS1-EBZ SPI-I2C-bridge driver"
1182 Support for the SPI-I2C bridge found on the Analog Devices
1183 AD-FMCOMMS1-EBZ board.
1220 tristate "Xilinx Zynq QSPI controller"
1229 tristate "Xilinx ZynqMP GQSPI controller"
1254 select one or more specific mux-controller drivers.
1298 If your system has a slave-capable SPI controller, you can enable