Lines Matching +full:txpower +full:- +full:5 +full:g

1 /* SPDX-License-Identifier: GPL-2.0-or-later */
3 	Copyright (C) 2004 - 2009 Ivo van Doorn <[email protected]>
27  * Default offset is required for RSSI <-> dBm conversion.
76  * 16 entries 32-byte for shared key table
77  * 64 entries 32-byte for pairwise key table
78  * 64 entries 8-byte for pairwise ta key table
113  * On-chip BEACON frame space.
158  *	Used to mask off bits from byte 5 of the MAC address
180  *	This mask is used to mask off bits 0 and 1 of byte 5 of the
183  *		0: 1-BSSID mode (BSS index = 0)
184  *		1: 2-BSSID mode (BSS index: Byte5, bit 0)
185  *		2: 2-BSSID mode (BSS index: byte5, bit 1)
186  *		3: 4-BSSID mode (BSS index: byte5, bit 0 - 1)
214  * MAC_CSR9: Back-Off control register.
216  * CWMIN: Bit for Cwmin. default Cwmin is 31 (2^5 - 1).
217  * CWMAX: Bit for Cwmax, default Cwmax is 1023 (2^10 - 1).
375  * TXRX_CSR4: Auto-Responder/Tx-retry register.
378  * OFDM_TX_RATE_STEP: 0:1-step, 1: 2-step, 2:3-step, 3:4-step.
425  * TSF_SYNC: Tsf sync, 0: disable, 1: infra, 2: ad-hoc/master mode.
487  * PHY_CSR2: Pre-TX BBP control.
666  * RX QOS-CFPOLL MAC address register.
667  * QOS_CSR3: RX QOS-CFPOLL MAC address 0.
668  * QOS_CSR4: RX QOS-CFPOLL MAC address 1.
674  * QOS_CSR5: "QosControl" field of the RX QOS-CFPOLL.
756  * FRAME_END: 1 - DPDT, 0 - SPDT (Only valid for 802.11G, RF2527 & RF2529)
809  * FRAME_TYPE: 0: DPDT , 1: SPDT , noted this bit is valid for g only.
832  * GEO_A: Default geographical setting for 5GHz band
848  * EEPROM TXPOWER 802.11G
887  * EEPROM TXPOWER 802.11A
923  * KEY_TABLE: Use per-client pairwise KEY table.
1043  * the above 20-byte is called RXINFO and will be DMAed to MAC RX block
1055  * Macros for converting txpower from EEPROM to mac80211 value