Lines Matching +full:super +full:- +full:frames
1 /* SPDX-License-Identifier: BSD-3-Clause-Clear */
3 * Copyright (c) 2018-2021 The Linux Foundation. All rights reserved.
4 * Copyright (c) 2021-2024 Qualcomm Innovation Center, Inc. All rights reserved.
257 * field in address search failure cache-only entry should
261 * If set, intra-BSS routing detection is enabled
279 * buffer management for WiFi-to-PPE routing.
282 * by a different subsystem, completely disabling WiFi-to-PPE
319 * When set, all frames (data only ?) shall be encrypted. If
358 * SW processes frames based on certain classifications. Values
492 * received MPDU in the PPDU and this MPDU gets filtered-in,
501 * Received frame was part of an A-MPDU.
515 * A-MPDU frame but a stand alone MPDU. Interior MPDU in an
516 * A-MPDU shall have both first_mpdu and last_mpdu bits set to
539 * Set if packet is not a non-QoS data frame. Only set when
571 * U-APSD trigger frame
602 * RXOLE uses this to determine intra-BSS routing.
605 * Opaque service code between PPE and Wi-Fi
621 * data frames to multi-link addresses during decapsulation to eth/nwifi
624 * Multi-link receiver address1,2. Only valid when corresponding
628 * If not set, RXDMA shall perform error-routing for WDS packets
899 * SW processes frames based on certain classifications. Values
913 * A-MPDU delimiter or the preamble length field for non-A-MPDU
914 * frames.
917 * Indicates the super filter rule.
944 * of a dynamic A-MSDU when DA is compressed.
948 * of a dynamic A-MSDU when SA is compressed.
951 * The 16-bit type value indicating the type of L3 later
1004 * Indicates the first MSDU of A-MSDU. If both first_msdu and
1005 * last_msdu are set in the MSDU then this is a non-aggregated MSDU
1006 * frame: normal MPDU. Interior MSDU in an A-MSDU shall have both
1010 * Indicates the last MSDU of the A-MSDU. MPDU end status is only
1052 * Set by RXOLE if it stripped 4-bytes of C-VLAN Tag from the
1056 * Set by RXOLE if it stripped 4-bytes of S-VLAN Tag from the
1110 * A-MSDU could not be properly de-agregated.
1120 * Opaque service code between PPE and Wi-Fi
1126 * This packet needs intra-BSS routing by SW as the 'vdev_id'
1132 * to support intra-BSS routing with multi-chip multi-link
1160 * This field is still valid for MPDU frames without A-MSDU.
1213 * number is non-zero. If set indicates that this is a fragmented
1225 * 0 - Toeplitz hash of 2-tuple (IP source address, IP
1227 * 1 - Toeplitz hash of 4-tuple (IP source address,
1230 * 2 - Toeplitz of flow_id
1231 * 3 - Zero is used
1234 * Fixed 20-byte IPv4 header or 40-byte IPv6 header parsed
1243 * Fixed 20-byte TCP (excluding TCP options) or 8-byte UDP
1257 * 2 bytes of C-VLAN Tag Control Information from WHO_L2_LLC
1260 * 2 bytes of S-VLAN Tag Control Information from WHO_L2_LLC
1298 * 0 - spatial stream not used for this reception
1299 * 1 - spatial stream used for this reception
1305 * are all valid. This bit is in the last 64-bit of the descriptor
1309 * Toeplitz hash of 5-tuple
1311 * destination port, L4 protocol} in case of non-IPSec.
1313 * In case of IPSec - Toeplitz hash of 4-tuple
1332 * IPv4/IPv6 - Either, Toeplitz hash computed over 2-tuple
1334 * hash computed over 4-tuple IPv4 or IPv6 src/dest addresses
1337 * is the one used for hash-based REO routing (see use_flow_id_toeplitz_clfy
1346 * A-MPDU frame but a stand alone MPDU. Interior MPDU in an
1347 * A-MPDU shall have both first_mpdu and last_mpdu bits set to
1370 * Set if packet is not a non-QoS data frame. Only set when
1394 * Set if number of MSDUs in A-MSDU is above a threshold or if the
1435 * Indicates that an A-MSDU with 'from DS = 0' had an SA mismatching
1436 * TA or an A-MDU with 'to DS = 0' had a DA mismatching RA
1459 * Indicates that the MPDU was pre-maturely terminated