Lines Matching +full:system +full:- +full:on +full:- +full:a +full:- +full:chip
1 # SPDX-License-Identifier: GPL-2.0-only
2 menu "Self-contained MTD device drivers"
3 depends on MTD!=n
4 depends on HAS_IOMEM
8 depends on PCI
10 This provides a MTD device driver for the Ramix PMC551 RAM PCI card
12 These devices come in memory configurations from 32M - 1G. If you
15 If this driver is compiled as a module you get the ability to select
17 What this means is that if you have a 1G card, normally the kernel
18 will use a 1G memory map as its view of the device. As a module,
19 you can select a 1M window into the memory and the driver will
21 particularly useful on the 2.2 kernels on PPC architectures as there
26 depends on MTD_PMC551
34 depends on MTD_PMC551
37 is only really useful if you are developing on this driver or
38 suspect a possible hardware or driver bug. If unsure say N.
41 tristate "DEC MS02-NV NVRAM module support"
42 depends on MACH_DECSTATION
44 This is an MTD driver for the DEC's MS02-NV (54-20948-01) battery
45 backed-up NVRAM module. The module was originally meant as an NFS
46 accelerator. Say Y here if you have a DECstation 5000/2x0 or a
47 DECsystem 5900 equipped with such a module.
49 If you want to compile this driver as a module ( = code which can be
52 The module will be called ms02-nv.
56 depends on SPI_MASTER
59 Sometimes DataFlash chips are packaged inside MMC-format
64 depends on MTD_DATAFLASH
67 It may help if you are verifying chip setup (timings etc) on
68 your board. There is a rare possibility that even though the
69 device thinks the write was successful, a bit could have been
74 depends on MTD_DATAFLASH
77 one-time-programmable (OTP) data. The first half may be written
78 (once) with up to 64 bytes of data, such as a serial number or
79 other key product data. The second half is programmed with a
80 unique-to-each-chip bit pattern at the factory.
84 depends on SPI_MASTER
88 Set up your spi devices with the right board-specific
89 platform data, or a device tree description if you want to
94 depends on SPI_MASTER
100 depends on PLAT_SPEAR || COMPILE_TEST
103 This enable SNOR support on SPEAR platforms using SMI controller
107 depends on SPI_MASTER
112 Set up your spi devices with the right board-specific platform data,
116 tristate "Support for serial flash on BCMA bus"
117 depends on BCMA_SFLASH && (MIPS || ARM)
124 tristate "Uncached system RAM"
128 present it to the system as a Memory Technology Device.
131 tristate "Physical system RAM"
133 This is a re-implementation of the slram driver above.
137 memory on the video card, etc...
142 This enables a test MTD device driver which uses vmalloc() to
148 depends on MTD_MTDRAM
153 as a module, it is also possible to specify this as a parameter when
158 depends on MTD_MTDRAM
163 as a module, it is also possible to specify this as a parameter when
168 depends on BLOCK
170 This driver allows a block device to appear as an MTD. It would
174 the system as an ATA drive.
175 Testing MTD users (eg JFFS2) on large media and media that might
176 be removed during a write (using the floppy drive).
180 depends on PPC_POWERNV
182 This provides an MTD device to access flash on powernv OPAL
186 comment "Disk-On-Chip Device Drivers"
189 tristate "M-Systems Disk-On-Chip G3"
194 This provides an MTD device driver for the M-Systems DiskOnChip
198 M-Systems and now Sandisk. The support is very experimental,
203 depends on ARCH_STI
207 for a subset of connected Serial Flash devices.