Lines Matching full:integration

32 /* pac1921 integration configuration bits */
63 /* Time from Sleep State to Start of Integration Period (tSLEEP_TO_INT) */
115  * integration period.
117  * Changing the number of samples affects the integration period: higher the
118  * number of samples, longer the integration period.
127  * The integration period depends on the configuration of number of integration
129  * contains integration periods, in microsecs unit, based on table 4-5 from
130  * datasheet considering power integration mode, 14-Bit resolution and post
217  * Check if first integration after configuration update has completed.
230 		 * Data valid after the device entered into integration state,  in pac1921_data_ready()
232 		 * and completed the first integration period.  in pac1921_data_ready()
431 		 * The integration period depends on the number of integration  in pac1921_read_raw()
463  * write the config register and set the device back into integration state.
464  * Also reset integration start time and mark first integration to be yet
483 	/* Re-enable integration */  in pac1921_update_cfg_reg()
490 	 * Reset integration started time and mark this integration period as  in pac1921_update_cfg_reg()
492 	 * only at the end of this integration period.  in pac1921_update_cfg_reg()
603  * Update the device with the given number of integration samples.
1056  * integration state.
1080 	 * Configure integration:  in pac1921_init()
1081 	 * - num of integration samples  in pac1921_init()
1095 	 * - VPower free run integration mode  in pac1921_init()
1105 	/* Enable integration */  in pac1921_init()
1172 …s/aemDocuments/documents/OTH/ApplicationNotes/ApplicationNotes/PAC193X-Integration-Notes-for-Micro…