Lines Matching +full:wakeup +full:- +full:source
1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (C) 2013 Texas Instruments Incorporated - https://www.ti.com/
5 /dts-v1/;
7 #include <dt-bindings/input/input.h>
9 #include "omap-gpmc-smsc911x.dtsi"
13 compatible = "ti,omap3-ldp", "ti,omap3430", "ti,omap3";
22 cpu0-supply = <&vcc>;
27 compatible = "gpio-keys";
28 pinctrl-names = "default";
29 pinctrl-0 = <&gpio_key_pins>;
35 wakeup-source;
42 wakeup-source;
49 wakeup-source;
56 wakeup-source;
63 wakeup-source;
70 wakeup-source;
77 wakeup-source;
84 wakeup-source;
91 wakeup-source;
101 compatible = "ti,omap2-nand";
103 interrupt-parent = <&gpmc>;
106 nand-bus-width = <16>;
107 gpmc,device-width = <2>;
108 ti,nand-ecc-opt = "bch8";
110 gpmc,sync-clk-ps = <0>;
111 gpmc,cs-on-ns = <0>;
112 gpmc,cs-rd-off-ns = <44>;
113 gpmc,cs-wr-off-ns = <44>;
114 gpmc,adv-on-ns = <6>;
115 gpmc,adv-rd-off-ns = <34>;
116 gpmc,adv-wr-off-ns = <44>;
117 gpmc,we-off-ns = <40>;
118 gpmc,oe-off-ns = <54>;
119 gpmc,access-ns = <64>;
120 gpmc,rd-cycle-ns = <82>;
121 gpmc,wr-cycle-ns = <82>;
122 gpmc,wr-access-ns = <40>;
123 gpmc,wr-data-mux-bus-ns = <0>;
125 #address-cells = <1>;
126 #size-cells = <1>;
129 label = "X-Loader";
133 label = "U-Boot";
151 interrupt-parent = <&gpio5>;
158 clock-frequency = <2600000>;
163 interrupt-parent = <&intc>;
166 compatible = "ti,twl4030-power-idle";
174 #include "omap3-panel-sharp-ls037v7dw01.dtsi"
181 clock-frequency = <400000>;
185 clock-frequency = <400000>;
190 regulator-always-on;
194 enable-gpios = <&twl_gpio 15 GPIO_ACTIVE_HIGH>; /* lcd INI */
195 reset-gpios = <&gpio2 23 GPIO_ACTIVE_HIGH>; /* gpio55, lcd RESB */
196 mode-gpios = <&gpio2 24 GPIO_ACTIVE_HIGH>; /* gpio56, lcd MO */
201 interrupt-parent = <&gpio2>;
203 pendown-gpio = <&gpio2 22 GPIO_ACTIVE_HIGH>;
209 compatible = "ti,omap3-pre-es3-hsmmc";
210 vmmc-supply = <&vmmc1>;
211 bus-width = <4>;
212 pinctrl-names = "default";
213 pinctrl-0 = <&mmc1_pins>;
225 gpio_key_pins: gpio-key-pins {
226 pinctrl-single,pins = <
239 musb_pins: musb-pins {
240 pinctrl-single,pins = <
256 mmc1_pins: mmc1-pins {
257 pinctrl-single,pins = <
289 interrupts-extended = <&intc 74 &omap3_pmx_core OMAP3_UART3_RX>;
293 pinctrl-names = "default";
294 pinctrl-0 = <&musb_pins>;
295 interface-type = <0>;
296 usb-phy = <&usb2_phy>;
303 regulator-name = "vcc";