Lines Matching +full:codec +full:- +full:gpio7
1 // SPDX-License-Identifier: GPL-2.0+
6 /dts-v1/;
7 #include <dt-bindings/input/input.h>
12 compatible = "fsl,imx53-smd", "fsl,imx53";
19 gpio-keys {
20 compatible = "gpio-keys";
22 key-volume-up {
28 key-volume-down {
37 pinctrl-names = "default";
38 pinctrl-0 = <&pinctrl_esdhc1>;
39 cd-gpios = <&gpio3 13 GPIO_ACTIVE_LOW>;
40 wp-gpios = <&gpio4 11 GPIO_ACTIVE_HIGH>;
45 pinctrl-names = "default";
46 pinctrl-0 = <&pinctrl_esdhc2>;
47 non-removable;
52 pinctrl-names = "default";
53 pinctrl-0 = <&pinctrl_uart3>;
54 uart-has-rtscts;
59 pinctrl-names = "default";
60 pinctrl-0 = <&pinctrl_ecspi1>;
61 cs-gpios = <&gpio2 30 GPIO_ACTIVE_LOW>, <&gpio3 19 GPIO_ACTIVE_LOW>;
66 spi-max-frequency = <8000000>;
71 #address-cells = <1>;
72 #size-cells = <1>;
73 compatible = "st,m25p32", "jedec,spi-nor";
74 spi-max-frequency = <20000000>;
78 label = "U-Boot";
80 read-only;
91 pinctrl-names = "default";
92 pinctrl-0 = <&pinctrl_esdhc3>;
93 non-removable;
98 pinctrl-names = "default";
99 pinctrl-0 = <&pinctrl_hog>;
237 pinctrl-names = "default";
238 pinctrl-0 = <&pinctrl_uart1>;
243 pinctrl-names = "default";
244 pinctrl-0 = <&pinctrl_uart2>;
249 pinctrl-names = "default";
250 pinctrl-0 = <&pinctrl_i2c2>;
253 codec: sgtl5000@a { label
270 pinctrl-names = "default";
271 pinctrl-0 = <&pinctrl_i2c1>;
282 pinctrl-names = "default";
283 pinctrl-0 = <&pinctrl_ov5642>;
284 assigned-clocks = <&clks IMX5_CLK_SSI_EXT1_SEL>,
286 assigned-clock-parents = <&clks IMX5_CLK_PLL2_SW>,
288 assigned-clock-rates = <0>, <24000000>;
290 clock-names = "xclk";
291 DVDD-supply = <&ldo9_reg>;
292 AVDD-supply = <&ldo7_reg>;
293 reset-gpios = <&gpio6 9 GPIO_ACTIVE_LOW>;
294 powerdown-gpios = <&gpio6 10 GPIO_ACTIVE_HIGH>;
298 remote-endpoint = <&ipu_csi0_from_parallel_sensor>;
299 bus-width = <8>;
300 hsync-active = <1>;
301 vsync-active = <1>;
309 interrupt-parent = <&gpio7>;
314 regulator-min-microvolt = <1200000>;
315 regulator-max-microvolt = <3600000>;
319 regulator-min-microvolt = <1250000>;
320 regulator-max-microvolt = <3650000>;
327 pinctrl-names = "default";
328 pinctrl-0 = <&pinctrl_fec>;
329 phy-mode = "rmii";
330 phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_LOW>;
335 remote-endpoint = <&ov5642_to_ipu_csi0>;
336 data-shift = <12>; /* Lines 19:12 used */
337 hsync-active = <1>;
338 vsync-active = <1>;
342 pinctrl-names = "default";
343 pinctrl-0 = <&pinctrl_ipu_csi0>;