Lines Matching +full:ulpi +full:- +full:0
1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright 2012 Sascha Hauer, Uwe Kleine-König, Steffen Trumtrar
7 /dts-v1/;
12 compatible = "phytec,imx27-pca100", "fsl,imx27";
16 reg = <0xa0000000 0x08000000>; /* 128MB */
20 compatible = "usb-nop-xceiv";
21 pinctrl-names = "default";
22 pinctrl-0 = <&pinctrl_usbotgphy>;
23 reset-gpios = <&gpio2 25 GPIO_ACTIVE_LOW>;
24 #phy-cells = <0>;
28 compatible = "usb-nop-xceiv";
29 pinctrl-names = "default";
30 pinctrl-0 = <&pinctrl_usbh2phy>;
31 reset-gpios = <&gpio2 22 GPIO_ACTIVE_LOW>;
32 #phy-cells = <0>;
37 cs-gpios = <&gpio4 28 GPIO_ACTIVE_LOW>,
43 pinctrl-names = "default";
44 pinctrl-0 = <&pinctrl_fec1>;
49 pinctrl-names = "default";
50 pinctrl-0 = <&pinctrl_i2c2>;
56 reg = <0x52>;
61 imx27-phycard-s-som {
64 MX27_PAD_SD3_CMD__FEC_TXD0 0x0
65 MX27_PAD_SD3_CLK__FEC_TXD1 0x0
66 MX27_PAD_ATA_DATA0__FEC_TXD2 0x0
67 MX27_PAD_ATA_DATA1__FEC_TXD3 0x0
68 MX27_PAD_ATA_DATA2__FEC_RX_ER 0x0
69 MX27_PAD_ATA_DATA3__FEC_RXD1 0x0
70 MX27_PAD_ATA_DATA4__FEC_RXD2 0x0
71 MX27_PAD_ATA_DATA5__FEC_RXD3 0x0
72 MX27_PAD_ATA_DATA6__FEC_MDIO 0x0
73 MX27_PAD_ATA_DATA7__FEC_MDC 0x0
74 MX27_PAD_ATA_DATA8__FEC_CRS 0x0
75 MX27_PAD_ATA_DATA9__FEC_TX_CLK 0x0
76 MX27_PAD_ATA_DATA10__FEC_RXD0 0x0
77 MX27_PAD_ATA_DATA11__FEC_RX_DV 0x0
78 MX27_PAD_ATA_DATA12__FEC_RX_CLK 0x0
79 MX27_PAD_ATA_DATA13__FEC_COL 0x0
80 MX27_PAD_ATA_DATA14__FEC_TX_ER 0x0
81 MX27_PAD_ATA_DATA15__FEC_TX_EN 0x0
87 MX27_PAD_I2C2_SDA__I2C2_SDA 0x0
88 MX27_PAD_I2C2_SCL__I2C2_SCL 0x0
94 MX27_PAD_NFRB__NFRB 0x0
95 MX27_PAD_NFCLE__NFCLE 0x0
96 MX27_PAD_NFWP_B__NFWP_B 0x0
97 MX27_PAD_NFCE_B__NFCE_B 0x0
98 MX27_PAD_NFALE__NFALE 0x0
99 MX27_PAD_NFRE_B__NFRE_B 0x0
100 MX27_PAD_NFWE_B__NFWE_B 0x0
106 MX27_PAD_USBH1_RCV__GPIO2_25 0x1 /* reset gpio */
112 MX27_PAD_USBOTG_CLK__USBOTG_CLK 0x0
113 MX27_PAD_USBOTG_DIR__USBOTG_DIR 0x0
114 MX27_PAD_USBOTG_NXT__USBOTG_NXT 0x0
115 MX27_PAD_USBOTG_STP__USBOTG_STP 0x0
116 MX27_PAD_USBOTG_DATA0__USBOTG_DATA0 0x0
117 MX27_PAD_USBOTG_DATA1__USBOTG_DATA1 0x0
118 MX27_PAD_USBOTG_DATA2__USBOTG_DATA2 0x0
119 MX27_PAD_USBOTG_DATA3__USBOTG_DATA3 0x0
120 MX27_PAD_USBOTG_DATA4__USBOTG_DATA4 0x0
121 MX27_PAD_USBOTG_DATA5__USBOTG_DATA5 0x0
122 MX27_PAD_USBOTG_DATA6__USBOTG_DATA6 0x0
123 MX27_PAD_USBOTG_DATA7__USBOTG_DATA7 0x0
129 MX27_PAD_USBH1_SUSP__GPIO2_22 0x0 /* reset gpio */
135 MX27_PAD_USBH2_CLK__USBH2_CLK 0x0
136 MX27_PAD_USBH2_DIR__USBH2_DIR 0x0
137 MX27_PAD_USBH2_NXT__USBH2_NXT 0x0
138 MX27_PAD_USBH2_STP__USBH2_STP 0x0
139 MX27_PAD_CSPI2_SCLK__USBH2_DATA0 0x0
140 MX27_PAD_CSPI2_MOSI__USBH2_DATA1 0x0
141 MX27_PAD_CSPI2_MISO__USBH2_DATA2 0x0
142 MX27_PAD_CSPI2_SS1__USBH2_DATA3 0x0
143 MX27_PAD_CSPI2_SS2__USBH2_DATA4 0x0
144 MX27_PAD_CSPI1_SS2__USBH2_DATA5 0x0
145 MX27_PAD_CSPI2_SS0__USBH2_DATA6 0x0
146 MX27_PAD_USBH2_DATA7__USBH2_DATA7 0x0
153 pinctrl-names = "default";
154 pinctrl-0 = <&pinctrl_nfc>;
155 nand-bus-width = <8>;
156 nand-ecc-mode = "hw";
157 nand-on-flash-bbt;
162 pinctrl-names = "default";
163 pinctrl-0 = <&pinctrl_usbotg>;
164 phy_type = "ulpi";
170 pinctrl-names = "default";
171 pinctrl-0 = <&pinctrl_usbh2>;
172 phy_type = "ulpi";