Lines Matching +full:rx +full:- +full:sample +full:- +full:delay +full:- +full:ns
1 .. SPDX-License-Identifier: GPL-2.0
32 IP_MULTICAST_LOOP + SO_TIMESTAMP[NS]
43 -------------------------------------------------------------
59 -------------------------------------------------------------------
62 Its struct timespec allows for higher resolution (ns) timestamps than the
72 ----------------------------------------------------------------------
102 Request rx timestamps generated by the network adapter.
105 Request rx timestamps when data enters the kernel. These timestamps
122 transmit latency is, if long, often dominated by queuing delay. The
131 grained measurement of queuing delay. This flag can be enabled
138 over-report measurement, because the timestamp is generated when all
181 is derived from a per-socket u32 counter (that wraps). For datagram
204 cmsg->cmsg_level = SOL_SOCKET;
205 cmsg->cmsg_type = SCM_TS_OPT_ID;
206 cmsg->cmsg_len = CMSG_LEN(sizeof(__u32));
222 a timestamp with counter N-1. SOF_TIMESTAMPING_OPT_ID_TCP
272 received the packet and its length at layer 2. A valid (non-zero)
297 ignore the unexpected non-zero value. But it makes behavior subtly
317 Using this feature, applications can sample timestamps per sendmsg()
324 cmsg->cmsg_level = SOL_SOCKET;
325 cmsg->cmsg_type = SO_TIMESTAMPING;
326 cmsg->cmsg_len = CMSG_LEN(sizeof(__u32));
344 -------------------------
354 correlating a timestamp with data is non-trivial. A range of bytes
383 relevant sequence number in skb_shinfo(skb)->tskey. Because an skbuff
392 autocork. After linux-4.7, a better way to prevent coalescing is
414 ----------------------------
437 feature. At least one field is non-zero at any time. Most timestamps
444 as linuxptp. For the PTP clock API, see Documentation/driver-api/ptp.rst.
481 is the first if ts[2] is non-zero, the second otherwise, in which
509 Reading from the error queue is always a non-blocking operation. To
574 If the requested fine-grained filtering for incoming packets is not
581 /* possible values for hwtstamp_config->tx_type */
599 /* possible values for hwtstamp_config->rx_filter */
619 --------------------------------------------------------
640 - In hard_start_xmit(), check if (skb_shinfo(skb)->tx_flags & SKBTX_HW_TSTAMP)
641 is set no-zero. If yes, then the driver is expected to do hardware time
643 - If this is possible for the skb and requested, then declare
645 SKBTX_IN_PROGRESS in skb_shinfo(skb)->tx_flags , e.g. with::
647 skb_shinfo(skb)->tx_flags |= SKBTX_IN_PROGRESS;
653 - Driver should call skb_tx_timestamp() as close to passing sk_buff to hardware
656 - As soon as the driver has sent the packet and/or obtained a
668 ----------------------------------------------------------
685 interface (redirecting to the host port on TX, and intercepting frames on RX).
688 suffer, since the switch's variable queuing delay introduces a path delay
709 - ``.port_txtstamp()``: a hook called prior to the transmission of
711 This is required for two-step timestamping, since the hardware
714 packet so that it can re-enqueue the packet back into the socket's
717 in skb->cb and enqueue a tx skb queue. Typically, a switch will have a
720 key-value pairs of PTP sequence ID/message type/domain number and the
728 One-step TX timestamping do not require packet cloning, since there is
729 no follow-up message required by the PTP protocol (because the
732 to be re-enqueued into its socket's error queue.
734 - ``.port_rxtstamp()``: On RX, the BPF classifier is run by DSA to
739 timestamps might either be available in-band (through metadata in the
740 DSA header, or attached in other ways to the packet), or out-of-band
741 (through another RX timestamping FIFO). Deferral on RX is typically
756 mii_timestamper`` and add a pointer to it in ``phydev->mii_ts``. The presence
764 - Checking, in ``.ndo_eth_ioctl``, whether ``phy_has_hwtstamp(netdev->phydev)``
768 - On RX, special intervention may or may not be needed, depending on the
771 ``skb_defer_rx_timestamp(skb)`` is necessary or not - and if it is, don't
773 enabled, and ``skb->dev->phydev->mii_ts`` exists, its ``.rxtstamp()`` hook
775 deferral for RX timestamping is necessary. Again like DSA, it becomes the
784 - On TX, again, special intervention might or might not be needed. The
785 function that calls the ``mii_ts->txtstamp()`` hook is named
806 Stacked PHCs, especially DSA (but not only) - since that doesn't require any
808 all possible code paths - is that they uncover bugs which were impossible to
812 skb_shinfo(skb)->tx_flags |= SKBTX_IN_PROGRESS;
823 the ``.ndo_eth_ioctl`` ("``priv->hwtstamp_tx_enabled == true``") and the
824 current skb requires a TX timestamp ("``skb_shinfo(skb)->tx_flags &
826 "``skb_shinfo(skb)->tx_flags |= SKBTX_IN_PROGRESS``" flag. Note: as
834 "``skb_shinfo(skb)->tx_flags & SKBTX_IN_PROGRESS``" was set. With a stacked
841 "``skb_shinfo(skb)->tx_flags & SKBTX_IN_PROGRESS``", but also for
842 "``priv->hwtstamp_tx_enabled == true``". Because the rest of the system ensures