Lines Matching +full:default +full:- +full:tap
4 Copyright (C) 2007-2008 Arjan Opmeer <[email protected]>
25 5.2.1 Parity checking and packet re-synchronization
102 "2" will turn on packet debugging. For hardware version 1 the default is
103 OFF. For version 2 the default is "1".
114 non-zero value will turn it ON. For hardware version 1 the default is ON.
115 For version 2 the default it is OFF.
124 default. Currently even turning it on will do nothing.
145 4 bytes version: (after the arrow is the name given in the Dell-provided driver)
173 ---------
179 echo -n 0x16 > reg_10
192 C: 1 = enable corner tap
216 0xff = tap again to release)
220 tap make timeout?
224 tap release timeout?
236 -----------------------------------------
247 c = 1 when corner tap detected
255 byte 1 = 0xf0 when corner tap detected
275 when corner tap detected:
298 -----------------------------------------
360 ---------
366 echo -n 0x56 > reg_10
389 0x7f = never i.e. tap again to release)
393 -----------------------------------------
395 Parity checking and packet re-synchronization
486 two fingers, but only the pair of the lower-left and upper-right coordinates.
503 ax8..ax0 = lower-left finger absolute x value
510 ay8..ay0 = lower-left finger absolute y value
522 bx8..bx0 = upper-right finger absolute x value
529 by8..by0 = upper-right finger absolute y value
535 ---------
548 -----------------------------------------
550 1 and 3 finger touch shares the same 6-byte packet format, except that
626 ---------
636 -----------------------------------------
749 w = 1 when delta overflows (> 127 or < -128), in this case
795 ---------
800 -----------------------------------------