Lines Matching full:returned
28 These are returned as negative numbers from most calls, with zero or
34 codes that may be returned, and other cases where these codes should
35 be returned. However, drivers should not return other codes for these
38 Also, codes returned by adapter probe methods follow rules which are
43 Returned by I2C adapters not supporting 10 bit addresses when
47 Returned by I2C adapters when they lose arbitration in master
51 Also returned when trying to invoke an I2C operation in an
56 Returned by SMBus logic when an invalid Packet Error Code byte
65 Returned by SMBus adapters when the bus was busy for longer
81 Returned by driver probe() methods. This is a bit more
89 Returned by any component that can't allocate memory when
93 Returned by I2C adapters to indicate that the address phase
98 Returned by driver probe() methods to indicate that they
102 Returned by an adapter when asked to perform an operation
105 For example, this would be returned when an adapter that
118 Returned when slave does not conform to the relevant I2C
124 Returned when a transfer was requested using an adapter
128 This is returned by drivers when an operation took too much