Lines Matching +full:humidity +full:- +full:sensor

6   * Sensirion SHT3x-DIS
13         - https://sensirion.com/media/documents/213E6A3B/63A5A569/Datasheet_SHT3x_DIS.pdf
14 …- https://sensirion.com/media/documents/051DF50B/639C8101/Sensirion_Humidity_and_Temperature_Senso…
16   * Sensirion STS3x-DIS
23 …- https://sensirion.com/media/documents/1DA31AFD/61641F76/Sensirion_Temperature_Sensors_STS3x_Data…
24 …      - https://sensirion.com/media/documents/292A335C/65537BAF/Sensirion_Datasheet_STS32_STS33.pdf
28   - David Frey <[email protected]>
29   - Pascal Sachs <[email protected]>
32 -----------
34 This driver implements support for the Sensirion SHT3x-DIS and STS3x-DIS
35 series of humidity and temperature sensors. Temperature is measured in degrees
36 celsius, relative humidity is expressed as a percentage. In the sysfs interface,
41 Documentation/i2c/instantiating-devices.rst for methods to instantiate the
44 Even if sht3x sensor supports clock-stretch (blocking mode) and non-stretch
45 (non-blocking mode) in single-shot mode, this driver only supports the latter.
47 The sht3x sensor supports a single shot mode as well as 5 periodic measure
60 In the periodic measure mode, the sensor automatically triggers a measurement
61 with the configured update interval on the chip. When a temperature or humidity
63 the alert pin on the sensor is set to high.
64 When the temperature and humidity readings move back between the hysteresis
65 values, the alert bit is set to 0 and the alert pin on the sensor is set to
72 sysfs-Interface
73 ---------------
77 humidity1_input:    humidity input
80 humidity1_max:      humidity max value
81 humidity1_max_hyst: humidity hysteresis value for max limit
84 humidity1_min:      humidity min value
85 humidity1_min_hyst: humidity hysteresis value for min limit
88 humidity1_alarm:    alarm flag is set to 1 if the humidity is outside the
90 heater_enable:      heater enable, heating element removes excess humidity from
91 		    sensor:
93 			- 0: turned off
94 			- 1: turned on
97 		    by the sensor, the next faster interval is chosen
102                         - 0: low repeatability
103                         - 1: medium repeatability
104                         - 2: high repeatability
107 debugfs-Interface
108 -----------------
111 serial_number:      unique serial number of the sensor in decimal