Lines Matching +full:0 +full:- +full:datasheet
12 Datasheet: Not publicly available
26 Datasheet: Not publicly available
34 Datasheet: Once publicly available at the ITE website, but no longer
42 Datasheet: Once publicly available at the ITE website, but no longer
50 Datasheet: Once publicly available at the ITE website, but no longer
58 Datasheet: Once publicly available at the ITE website, but no longer
66 Datasheet: Not publicly available
74 Datasheet: Not publicly available
82 Datasheet: Not publicly available
90 Datasheet: Not publicly available
98 Datasheet: Not publicly available
106 Datasheet: Not publicly available
114 Datasheet: Not publicly available
122 Datasheet: Not publicly available
130 Datasheet: Not publicly available
138 Datasheet: Not publicly available
146 Datasheet: Not publicly available
154 Datasheet: Not publicly available
162 Datasheet: Not publicly available
170 Datasheet: No longer be available
174 - Christophe Gauthron
175 - Jean Delvare <[email protected]>
179 -----------------
182 0 if vbat should report power on value, 1 if vbat should be updated after
183 each read. Default is 0. On some boards the battery voltage is provided
188 battery life but no information is given in the datasheet.
192 misconfigured by BIOS - PWM values would be inverted. This option tries
198 For example "force_id=0x8689,0x8633". A value of 0 is ignored
200 Note: A single force_id value (e.g. "force_id=0x8689") is used for
201 all chips, to only set the first chip use "force_id=0x8689,0".
209 Provided since there are reports that system-wide acpi_enfore_resources=lax
217 -------------------
219 All the chips supported by this driver are LPC Super-I/O chips, accessed
220 through the LPC bus (ISA-like I/O ports). The IT8712F additionally has an
228 -----------
247 is stored in the Super-I/O configuration space. Due to technical limitations,
258 IT8783E/F, and late IT8712F and IT8705F also have optional 16-bit tachometer
260 not compatible with the older chips and revisions. The 16-bit tachometer mode
268 until a datasheet becomes available (hopefully.)
271 IT8728F. It only supports 3 fans, 16-bit fan mode, and the full speed mode
272 of the fan is not supported (value 0 of pwmX_enable).
275 to IT8728F. It only supports 16-bit fan mode. Both chips support up to 6 fans.
277 The IT8790E, IT8792E/IT8795E and IT87952E support up to 3 fans. 16-bit fan
280 The IT8732F supports a closed-loop mode for fan control, but this is not
288 16-bit tachometer counters aren't used, fan readings can be divided by
298 voltage inputs can measure voltages between 0 and 4.08 volts, with a resolution
299 of 0.016 volt. IT8603E, IT8721F/IT8758E and IT8728F can measure between 0 and
300 3.06 volts, with a resolution of 0.012 volt. IT8732F can measure between 0 and
310 The driver handles this transparently so user-space doesn't have to care.
321 once-only alarms.
323 Out-of-limit readings can also result in beeping, if the chip is properly
332 Give 0 for unused sensor. Any other value is invalid. To configure this at
338 -----------------
349 read-only.
353 -------------------------------------------
379 -----------------------------
381 The driver supports temp[1-3]_offset sysfs attributes to adjust the reported
382 temperature for thermal diodes or diode-connected thermal transistors.