Lines Matching +full:power +full:- +full:on +full:- +full:time +full:- +full:ms

47       - Christian W. Zuckschwerdt <[email protected]>
48       - valuable contributions by Jan M. Sendler <[email protected]>
49       - ported to 2.6 by Aurelien Jarno <[email protected]>
53 ------------------
62 -----------
66 programmed into non-volatile on-chip registers). Temperature range is -55
68 Fahrenheit range of -67 to +257 degrees with 0.9 steps. If polarity
72 toggle. On the one hand ("heater"), the thermostat output of the chip,
74 stays high until the high limit is met or exceeded. On the other hand
81 of up to +/- 0.5 degrees even when compared against precise temperature
91 any of the limits have ever been met or exceeded since last power-up or
102 also pin compatible with the DS1621 and provide multi-resolution support.
110 ----------------------
112 - DS1621 - 750ms (older devices may take up to 1000ms)
113 - DS1625 - 500ms
114 - DS1631 - 93ms..750ms for 9..12 bits resolution, respectively.
115 - DS1721 - 93ms..750ms for 9..12 bits resolution, respectively.
116 - DS1731 - 93ms..750ms for 9..12 bits resolution, respectively.
119 On the DS1621, internal access to non-volatile registers may last for 10ms
120 or less (unverified on the other devices).
123 --------------------
125 - DS1621: +/- 0.5 degree Celsius (from 0 to +70 degrees)
126 - DS1625: +/- 0.5 degree Celsius (from 0 to +70 degrees)
127 - DS1631: +/- 0.5 degree Celsius (from 0 to +70 degrees)
128 - DS1721: +/- 1.0 degree Celsius (from -10 to +85 degrees)
129 - DS1731: +/- 1.0 degree Celsius (from -10 to +85 degrees)
136 -----------------------
137 As mentioned above, the DS1631, DS1721, and DS1731 provide multi-resolution
141 ------
154    At initial device power-on, the default resolution is set to 12-bits.
162 Resolution    Conversion Time    Input Range
172 used to change the conversion time::
206 after a write operation provides the conversion time used by the device.
208 Mathematically, the resolution can be derived from the conversion time
215  - 'x' = the output from 'update_interval'
216  - 'g(x)' = the resolution in degrees C per LSB.
217  - 93.75ms = minimum conversion time