Lines Matching +full:per +full:- +full:board

25     - 2 ports multiport board
26 	CP-102U, CP-102UL, CP-102UF
27 	CP-132U-I, CP-132UL,
28 	CP-132, CP-132I, CP132S, CP-132IS,
29 	(CP-102, CP-102S)
31     - 4 ports multiport board
32 	CP-104EL,
33 	CP-104UL, CP-104JU,
34 	CP-134U, CP-134U-I,
36 	CP-114, CP-114I, CP-114S, CP-114IS, CP-114UL,
37 	(C114HI, CT-114I),
38 	POS-104UL,
39 	CB-114,
40 	CB-134I
42     - 8 ports multiport board
43 	CP-118EL, CP-168EL,
44 	CP-118U, CP-168U,
46 	CB-108
54     - msdiag
57     - msmon
59     - msterm     A simple terminal program which is useful in testing serial
70    or built-in into kernel (Static driver). Before you install the driver,
75    - Serial-HOWTO
76    - Kernel-HOWTO
81    - Maximum 4 boards can be installed in combination
89 PCI/UPCI board
90 --------------
97 ---------------
99    Each port within the same multiport board shares the same IRQ. Up to
111 -----------------------------------------------
113    Naming convention for each Smartio/Industio multiport board is
114    pre-defined as below.
117    Board Num.	Device node
118    1st board	ttyM0  - ttyM7
119    2nd board	ttyM8  - ttyM15
120    3rd board	ttyM16 - ttyM23
121    4th board	ttyM24 - ttyM31
131 msdiag - Diagnostic
135    board was found by the driver in the system.
137 msmon - Port Monitoring
144    Rx/Tx throughputs per second are also reported in interval basis (e.g.
146    is started). You can reset all ports' count by <HOME> key. <+> <->
151 msterm - Terminal Emulation
166    uart		  set UART type(16450 --> disable FIFO, 16550A --> enable FIFO)
192 	      More than 4 Moxa Smartio/Industio family boards found. Fifth board
196    To avoid this problem, please unplug fifth and after board, because Moxa