Lines Matching +full:firmware +full:- +full:initialised
1 # SPDX-License-Identifier: GPL-2.0
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Liam Girdwood <[email protected]>
11 - Mark Brown <[email protected]>
14 regulator-name:
18 regulator-min-microvolt:
21 regulator-max-microvolt:
24 regulator-microvolt-offset:
28 regulator-min-microamp:
31 regulator-max-microamp:
34 regulator-input-current-limit-microamp:
37 regulator-power-budget-milliwatt:
40 regulator-always-on:
44 regulator-boot-on:
45 description: bootloader/firmware enabled regulator.
53 regulator-allow-bypass:
57 regulator-allow-set-load:
61 regulator-ramp-delay:
63 disabling ramp rate, it should be explicitly initialised to zero (regulator-ramp-delay
67 regulator-enable-ramp-delay:
76 regulator-settling-time-us:
81 regulator-settling-time-up-us:
87 regulator-settling-time-down-us:
93 regulator-soft-start:
97 regulator-initial-mode:
103 regulator-allowed-modes:
105 for the regulator at run-time. Elements may be specified in any order.
109 $ref: /schemas/types.yaml#/definitions/uint32-array
111 regulator-system-load:
116 regulator-pull-down:
120 system-critical-regulator:
125 regulator-over-current-protection:
129 regulator-oc-protection-microamp:
135 regulator-oc-error-microamp:
141 regulator-oc-warn-microamp:
148 regulator-ov-protection-microvolt:
155 regulator-ov-error-microvolt:
162 regulator-ov-warn-microvolt:
170 regulator-uv-protection-microvolt:
177 regulator-uv-error-microvolt:
184 regulator-uv-warn-microvolt:
192 regulator-uv-less-critical-window-ms:
194 critical under-voltage event during which the system can continue to
197 under-voltage event is needed, allowing for certain non-urgent actions to
200 regulator-temp-protection-kelvin:
206 regulator-temp-error-kelvin:
212 regulator-temp-warn-kelvin:
219 regulator-active-discharge:
228 regulator-coupled-with:
230 is 2-way - all coupled regulators should be linked with each other.
232 $ref: /schemas/types.yaml#/definitions/phandle-array
236 regulator-coupled-max-spread:
239 couple specified by the regulator-coupled-with property.
240 $ref: /schemas/types.yaml#/definitions/uint32-array
242 regulator-max-step-microvolt:
247 ".*-supply$":
250 "^regulator-state-(standby|mem|disk)$":
253 sub-nodes for regulator state in Standby, Suspend-to-RAM, and
254 Suspend-to-DISK modes. Equivalent with standby, mem, and disk Linux
258 regulator-on-in-suspend:
262 regulator-off-in-suspend:
266 regulator-suspend-min-microvolt:
269 regulator-suspend-max-microvolt:
272 regulator-suspend-microvolt:
278 regulator-changeable-in-suspend:
283 regulator-mode:
295 - |
297 regulator-min-microvolt = <1000000>;
298 regulator-max-microvolt = <2500000>;
299 regulator-always-on;
300 vin-supply = <&vin>;
302 regulator-state-mem {
303 regulator-on-in-suspend;