Lines Matching +full:1 +full:ma

19   |_ PHY port#1 _________________ HOST controller
21   |                  / 1|________________|
34     maxItems: 1
37     maxItems: 1
40     maxItems: 1
43     const: 1
49     description: regulator providing 1V1 power supply to the PLL block
52     description: regulator providing 1V8 power supply to the PLL block
59     minItems: 1
65   "^usb-phy@[0|1]$":
73         maxItems: 1
110           - <1> increases the level by 5 to 7 mV
129           - <0> = 18.87 mA target current / nominal + 0%
130           - <1> = 19.165 mA target current / nominal + 1.56%
131           - <2> = 19.46 mA target current / nominal + 3.12%
132           - <3> = 19.755 mA target current / nominal + 4.68%
133           - <4> = 20.05 mA target current / nominal + 6.24%
134           - <5> = 20.345 mA target current / nominal + 7.8%
135           - <6> = 20.64 mA target current / nominal + 9.36%
136           - <7> = 20.935 mA target current / nominal + 10.92%
137           - <8> = 21.23 mA target current / nominal + 12.48%
138           - <9> = 21.525 mA target current / nominal + 14.04%
139           - <10> = 21.82 mA target current / nominal + 15.6%
140           - <11> = 22.115 mA target current / nominal + 17.16%
141           - <12> = 22.458 mA target current / nominal + 19.01%
142           - <13> = 22.755 mA target current / nominal + 20.58%
143           - <14> = 23.052 mA target current / nominal + 22.16%
144           - <15> = 23.348 mA target current / nominal + 23.73%
154           - <1> = reduce the impedance by 2 ohms
166           - <1> = threshold shift by +7 mV
182           - <1> = offset of +5 mV
214               const: 1
217                 0 for OTG controller and 1 for Host controller.
235   - usb-phy@1
250         #address-cells = <1>;
262             st,trim-hs-impedance = <1>;
272         usbphyc_port1: usb-phy@1 {
273             reg = <1>;
275             #phy-cells = <1>;
280             st,trim-hs-impedance = <1>;