Lines Matching +full:device +full:- +full:state +full:- +full:gpios
4 -------------------
5 - compatible: Must be one of
9 - reg: I2C device address.
12 -------------------
13 - interrupts: The interrupt on the parent the controller is
15 - interrupt-controller: Marks the device node as an interrupt controller.
16 - #interrupt-cells: is <2> and their usage is compliant to the 2 cells
17 variant of <../interrupt-controller/interrupts.txt>
19 are defined at dt-bindings/mfd/max77620.h.
21 - system-power-controller: Indicates that this PMIC is controlling the
24 [1] Documentation/devicetree/bindings/power/power-controller.txt
30 --------------------------------------
33 independently or among a group of other regulators with an adjustable power-up
34 and power-down delays (sequencing). GPIO1, GPIO2, and GPIO3 can be programmed
49 regulators, GPIOs and clocks specifies the enable source to be a flexible
51 the regulators, GPIOs and clocks flexible power sequencer configuration
54 When FPS event cleared (set to LOW), regulators, GPIOs and 32KHz
55 clock are set into following state at the sequencing event that
57 Sleep state: In this state, regulators, GPIOs
60 Global Low Power Mode (GLPM): In this state, regulators are set in
63 The configuration parameters of FPS is provided through sub-node "fps"
68 regulators, GPIOs and 32kHz clocks are provided in their respective
69 configuration nodes which is explained in respective sub-system DT
73 state like when system state changed from active to suspend or active to
77 -------------------
78 -maxim,fps-event-source: u32, FPS event source like external
82 dt-bindings/mfd/max77620.h
84 - MAX77620_FPS_EVENT_SRC_EN0
86 - MAX77620_FPS_EVENT_SRC_EN1
88 - MAX77620_FPS_EVENT_SRC_SW
91 -maxim,shutdown-fps-time-period-us: u32, FPS time period in microseconds
93 state.
95 -maxim,suspend-fps-time-period-us: u32, FPS time period in microseconds
96 when system enters in to suspend state.
98 -maxim,device-state-on-disabled-event: u32, describe the PMIC state when FPS
100 should go to sleep state or low-power
101 state. Following are valid values:
102 - MAX77620_FPS_INACTIVE_STATE_SLEEP
103 to set the PMIC state to sleep.
104 - MAX77620_FPS_INACTIVE_STATE_LOW_POWER
105 to set the PMIC state to low
108 will not change device state when FPS
111 Here supported time periods by device in microseconds are as follows:
116 -maxim,power-ok-control: configure map power ok bit
129 regulator, power, please refer respective device-tree binding document
130 under their respective sub-system directories.
133 --------
134 #include <dt-bindings/mfd/max77620.h>
140 interrupt-parent = <&intc>;
143 interrupt-controller;
144 #interrupt-cells = <2>;
148 maxim,shutdown-fps-time-period-us = <1280>;
149 maxim,fps-event-source = <MAX77620_FPS_EVENT_SRC_EN1>;
153 maxim,shutdown-fps-time-period-us = <1280>;
154 maxim,fps-event-source = <MAX77620_FPS_EVENT_SRC_EN0>;
158 maxim,shutdown-fps-time-period-us = <1280>;
159 maxim,fps-event-source = <MAX77620_FPS_EVENT_SRC_SW>;