Lines Matching full:sink

76       - sink
85       - sink
121   sink-vdos:
133   sink-vdos-v1:
215       is applied during PD3.0 Fast Role Swap. "Table 6-14 Fixed Supply PDO - Sink"
218       provides a detailed description of the field. The sink PDO from current source
220       requirement during fr swap. The current sink (i.e. receiver of the FRS signal),
222       new sink's, requirement during frswap before enabling the frs signal reception.
223       This property refers to maximum current capability that the current sink can
226       "1" refers to default USB power level as described by "Table 6-14 Fixed Supply PDO - Sink".
234       still comply to pSnkStby i.e Maximum power that can be consumed by sink while in Sink Standby
235       state as defined in 7.4.2 Sink Electrical Parameters of USB Power Delivery Specification
256   sink-wait-cap-time-ms:
257     description: Represents the max time in ms that USB Type-C port (in sink
259       SinkWaitCap timer starts when port in sink role attaches to the source.
260       This timer will stop when sink receives PD source cap advertisement before
270       timer starts when a sink's PHY layer receives EOP of the GoodCRC message
286   sink-bc12-completion-time-ms:
287     description: Represents the max time in ms that a port in sink role takes
291       connect as sink" state. In TCPCs where this causes delays to respond to
292       the incoming PD messages, sink-bc12-completion-time-ms is used to delay
304   sink-vdos-v1: [ sink-vdos ]
305   sink-vdos: [ sink-vdos-v1 ]
327       sink-pdos:
328         description: An array of u32 with each entry providing supported power sink
331           Sink Capabilities Message, the order of each entry(PDO) should follow the
332           PD spec chapter 6.4.1. Required for power sink and power dual role. User
333           can specify the sink PDO array via PDO_FIXED/BATT/VAR/PPS_APDO() defined
339       op-sink-microwatt:
340         description: Sink required operating power in microwatt, if source can't
341           offer the power, Capability Mismatch is set. Required for power sink and
438             try-power-role = "sink";
440             sink-pdos = <PDO_FIXED(5000, 2000, PDO_FIXED_USB_COMM)
442             op-sink-microwatt = <10000000>;
443             sink-wait-cap-time-ms = <465>;
446             sink-bc12-completion-time-ms = <500>;