Lines Matching +full:auto +full:- +full:detected

1 .. SPDX-License-Identifier: GPL-2.0
7 ---------------
13 There are two types of parameters - global / PCI card related, found under
23     | 0 - No module present
24     | 1 - FPDL3
25     | 2 - GMSL
33     | 1 - FPDL3
34     | 2 - GMSL
42         PRODUCT-REVISION-SERIES-SERIAL
55     | 0 - single
56     | 1 - dual (default)
61     | 0 - OLDI/JEIDA
62     | 1 - SPWG/VESA (default)
72     | 0 - unlocked
73     | 1 - locked
76     Video stream status. A stream is detected if the link is locked, the input
82     | 0 - not detected
83     | 1 - detected
86     Video stream width. This is the actual width as detected by the HW.
92     Video stream height. This is the actual height as detected by the HW.
98     The type of VSYNC pulses as detected by the video format detector.
103     | 0 - active low
104     | 1 - active high
105     | 2 - not available
108     The type of HSYNC pulses as detected by the video format detector.
113     | 0 - active low
114     | 1 - active high
115     | 2 - not available
187     | 0 - PLL < 50MHz (default)
188     | 1 - PLL >= 50MHz
205     | 0 - input 0
206     | 1 - input 1
207     | 2 - v4l2 output 0
208     | 3 - v4l2 output 1
241     | 0 - active low (default)
242     | 1 - active high
247     | 0 - active low (default)
248     | 1 - active high
253     | 0 - active low
254     | 1 - active high (default)
257     Output pixel clock frequency. Allowed values are between 25000-190000(kHz)
258     and there is a non-linear stepping between two consecutive allowed
295     | 0 - auto (default)
296     | 1 - single
297     | 2 - dual
305     | 0 - auto (default)
306     | 1 - single
307     | 2 - dual
315     | 0 - 12Gb/s (default)
316     | 1 - 6Gb/s
317     | 2 - 3Gb/s
318     | 3 - 1.5Gb/s
321     The GMSL multi-stream contains up to four video streams. This parameter
323     zero-based index of the stream. The default stream id is 0.
331     | 0 - disabled
332     | 1 - enabled (default)
335 --------------
338  - mgb4-fw.X - FPGA firmware.
339  - mgb4-data.X - Factory settings, e.g. card serial number.
341 The *mgb4-fw* partition is writable and is used for FW updates, *mgb4-data* is
342 read-only. The *X* attached to the partition name represents the card number.
344 also have a third partition named *mgb4-flash* available in the system. This
349 --------------
357 	| bit 1 - trigger 1 pending
358 	| bit 2 - trigger 2 pending
359 	| bit 5 - trigger 1 level
360 	| bit 6 - trigger 2 level
374 buffer mode - the values do not represent valid data in such case.*