Lines Matching +full:wakeup +full:- +full:mode
14 bit 8:0 -- Gap
15 bit 16:8 -- GPIO
18 It could be any valid GPIO pin# (e.g. 0-7) or 0xff (SDIO interface
19 wakeup will be used instead).
21 where Gap is the gap in milli seconds between wakeup signal and
22 wakeup event, or 0xff for special host sleep setting.
35 These commands are used to enable/disable auto sleep mode
39 1 -- Enable auto sleep mode
40 0 -- Disable auto sleep mode
44 # Enable auto sleep mode
48 # Disable auto sleep mode
58 1 -- Enable host sleep
59 0 -- Wake up firmware
106 hcitool cmd 0x3f 0x5b 0xf5 0x01 0x00 --Enable All interface
107 hcitool cmd 0x3f 0x5b 0xf5 0x01 0x01 --Enable Wlan interface
108 hcitool cmd 0x3f 0x5b 0xf5 0x01 0x02 --Enable BT interface
109 hcitool cmd 0x3f 0x5b 0xf5 0x00 0x00 --Disable All interface
110 hcitool cmd 0x3f 0x5b 0xf5 0x00 0x01 --Disable Wlan interface
111 hcitool cmd 0x3f 0x5b 0xf5 0x00 0x02 --Disable BT interface
118 - /lib/firmware/sd8688_helper.bin
119 - /lib/firmware/sd8688.bin
124 git.infradead.org/users/dwmw2/linux-firmware.git/libertas/